Honeywell 408EU manual followed by your User Code, System Operation cont’d, To Bypass a Zone

System Operation (cont’d)

To Arm the System In Instant Mode

In INSTANT mode, all alarm sensors, including doors that normally have a delay to allow you to disarm the system, will immediately report an alarm if activated. Check to make sure the system is ready. When it is ready, press:

INSTANT followed by your User Code.

When the system has been armed successfully, the ARMED LED is on, and the following is displayed:

LCD Keypad:

ON: INSTANT

Fixed-Word Keypad:

INSTANT

To Bypass a Zone

The Bypass function excludes a zone of protection from the security system until it is unbypassed (either by using the unbypass procedure or when you disarm the system). Bypassing can only be done while the system is disarmed.

Press the BYPASS button. Then enter your User Code and the zone number (1-8) to be bypassed, as follows:

BYPASS

followed by your User Code†

and Zone No. (1-8)

†If the Quick Bypass feature has been enabled by the installer, do not enter the User Code when bypassing zones.

– 13 –