Toshiba VF-A7 Example of control panel operation, Set the torque command, ＲＵＮ ：Starts the motor

■Example of control panel operation

1.Set the torque command.

Follow the steps described in the table below to set the torque command ().

2 ＲＵＮ ：Starts the motor

3.ＳＴＯＰ ：Stops the motor

Note)Pressing the Stop key causes the motor to coast to a stop.

Example of typical connection
			Motor
R/L1		U/T1	IM
S/L2		V/T2
T/L3		W/T3
		S4
G/E Operating panel CC			ON: Torque control
CC	RX II RR PP		OFF: Speed control

Control panel torque command 85%

Key operated		LED display	Operation
			The operation frequency is displayed. (Out of operation.)
			(If the monitor display mode setting parameter  is
			set at [Running frequency])
	MON		Press the [MON] key to call up the first basic
			parameter  (Automatic acceleration/deceleration)
▲	▼		Select  by pressing the △ or ▽ key.
	ENT		Press the Enter key to display the parameter setting.

▲ Select  by pressing the △ key.

ENT			Press the Enter key to display the parameter setting.
▲			Change the parameter setting (torque command) by
			pressing △key.
ENT		⇔	Press the Enter key to save the change. Then, 
			and the set value are displayed alternately.
MON	×３		Press the Monitor key three times in a row to display the
			frequency.
			Press the Run key to start the motor. According to the
RUN		⇒	torque, the motor accelerates to a frequency
			commensurate with the load.
			You can change the operation frequency anytime even
▲	▼		during operation, by pressing △ or ▽ key. (Change
			of the  setting)
STOP		⇒	Press the Stop key to stop the motor. The motor coasts
			to a stop. (Free-run stop)

C-15