Mocomtech CRS-300 Optional Message Arguments, End of Packet, Remote Commands and Queries

CRS-300 1:10 Redundancy Switch	Revision 16
Remote Control	MN/CRS300.IOM

C.5.6 Optional Message Arguments

Arguments are not required for all messages. Arguments are ASCII codes for the characters 0 to 9 (ASCII codes 48-57), A to Z (ASCII codes 65-90), period (ASCII code 46) and comma (ASCII code 44).

C.5.7 End of Packet

Controller-to-Target: This is the 'Carriage Return' character (ASCII code 13).

Target-to-Controller: This is the two-character sequence 'Carriage Return', 'Line Feed' (ASCII codes 13 and 10).

Both indicate the valid termination of a packet.

C.6 Remote Commands and Queries

Where Column ‘C’ = Command; Column ‘Q’ = Query: Columns marked (X) indicate Command only, Query only, or Command/Query for Instruction Code.

Instr	C	Q	Page
Code
AAM	X	X	C-7
ACT	X	X	C-7
AMQ		X	C-7
BBU	X	X	C-7
BKH	X	X	C-7
CAE	X		C-7
CLD	X		C-8
CST	X	X	C-8
DAY	X	X	C-8
EID		X	C-8
FLT		X	C-9
LRS	X	X	C-9
MAM	X	X	C-9
MOD		X	C-10

Instr	C	Q	Page
Code
NUE		X	C-10
OPM	X	X	C-10
PRI	X	X	C-10
RNE		X	C-11
RSH	X	X	C-11
SAM	X	X	C-12
SDT	X	X	C-12
SGC	X	X	C-12
SID	X	X	C-12
SNO		X	C-13
SWR		X	C-13
TIM	X	X	C-13
XMI		X	C-14

Note: The following codes are used in the ‘Response to Command’ column:

Code Meaning

=Message OK

?Received OK, but invalid arguments found

*Message OK, but not permitted in Current mode

#Message OK, but only permitted in Remote mode

~Timed out a pass-through message

!Unknown command

C–6