Mocomtech CRS-300 operation manual EN55024 1998 Compliance, Federal Communications Commission FCC

CRS-300 1:10 Redundancy Switch	Revision 16
Preface	MN/CRS300.IOM

EN55024 - 1998 Compliance

This equipment meets the EMC/immunity characteristics for the limits and methods of measurement for information technology equipment per EN55024-1998.

Federal Communications Commission (FCC)

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.

This equipment generates, uses, and can radiate radio frequency energy. If not installed and used in accordance with the instruction manual, it may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference; in which case, users are required to correct the interference at their own expense.

NOTE

To ensure compliance, properly shielded cables for DATA I/O shall be used. More specifically, these cables shall be shielded from end to end, ensuring a continuous shield.

Safety Compliance

EN 60950

Applicable testing is routinely performed as a condition of manufacturing on all units to ensure compliance with safety requirements of EN60950. This equipment meets the Safety of Information Technology Equipment specification as defined in EN60950.

Low Voltage Directive (LVD)

The following information is applicable for the European Low Voltage Directive (2006/95/EC):

<HAR> Type of power cord required for use in the European Community.

!CAUTION: Double-pole/Neutral Fusing

ACHTUNG: Zweipolige bzw. Neutralleiter-Sicherung

International Symbols:

Symbol Definition

~Alternating Current

Symbol Definition

Protective Earth / Safety Ground

Fuse

Chassis Ground

NOTE

For additional symbols, refer to Cautions and Warnings listed earlier in this Preface.

xvii