Mocomtech CRS-300 operation manual RMI Card CDM-570/570L, -600/600L, PL/9579-1

CRS-300 1:10 Redundancy Switch					Revision 16
Introduction					MN/CRS300.IOM
			CDM-625 Modem
	Data Type			TMI Type	RMI Type
	EIA-422, V.35			CRS-316Notes 5, 6
	10/100 Ethernet		Note 4
	ASI Notes 5, 6			CRS-325Notes 5, 6
	G.703	Bal (DDI, IDO, DDO, IDI) Note 2
	G.703	Unbal Note 2
	G.703	Bal (DDI, IDO, DDO, IDI) Note 2		CRS-330
	G.703	Unbal (DDI, IDO, DDO, IDI) Note 2			CRS-310
	HSSI		Note 4	CRS-336Notes 5, 6
	10/100 Ethernet
	EIA-422, V.35, LVDS			CRS-340 Note 3
	G.703	Bal (DDI, IDO, DDO, IDI) Note 2
	G.703	Unbal Notes 1, 2
	Quad E1			CDS-365DNotes 5, 6

Notes:

1.For CDM-600 modem to switch data (Bal and Unbal) use DB-15 to DB-15 data cable.

2.For CDM-625 modem to switch data (Bal and Unbal) use DB-9 to DB-15 data cable.

3.As of September 2008, the CRS-320 TMI is obsolete. Use the CRS-340 TMI in its place.

4.For CDM-625 where the terrestrial data type is Ethernet, the User can use only one of any four Ethernet ports on the CDM-625 rear panel in Ethernet Bridge Mode.

5.From Redundant Modem to RMI, use DB-25 to DB-25 Control cable.

6.From Traffic Modem to TMI, use DB-9 to HD-15 Control cable.

1.4.3.1RMI Card: CDM-570/570L, -600/600L, -625

(2X) BNC - Male DB-15 Male

Figure 1-5.

CRS-310 RMI

(PL/9579-1)

HD-50 Female DB-25 Male

1–9