CRS-300 1:10 Redundancy Switch

Revision 16

Introduction

MN/CRS300.IOM

1.2CRS-300 Compatibility

Table 1-1shows the Comtech EF Data modems that are compatible for use with the CRS-300 1:10 Redundancy Switch.

 

 

 

Table 1-1. CRS-300 Compatibility Table

 

 

 

 

 

 

Modem

 

 

Optional Switches

 

CDM-570

CRS-280 IF Switch (70/140 MHz)

 

 

 

 

 

CDM-570L

CRS-280L IF Switch (L-Band)

 

 

 

 

 

 

CDM-600 Note 1

 

CRS-280 IF Switch (70/140 MHz)

 

 

 

CRS-350 ESC Switch (IDR Overhead)

 

CDM-600L Note 1

 

CRS-280L IF Switch (L-Band)

 

 

 

CRS-350 ESC Switch (IDR Overhead)

 

CDM-625 Note 1

 

CRS-280L IF Switch (L-Band)

 

 

 

CRS-350 ESC Switch (IDR Overhead)

 

 

 

CRS-280 IF Switch (70/140 MHz)

 

CDM-Qx

 

 

 

 

 

 

Up to one modulator and one demodulator allowed per CDM-Qx/QxL.

 

 

 

 

 

 

 

NOTE

 

 

 

 

CRS-280L IF Switch (L-Band)

 

CDM-QxL

 

 

Up to one modulator and one demodulator allowed per CDM-Qx/QxL.

 

 

 

 

 

 

 

NOTE

 

 

CDM-700

 

CRS-280 IF Switch (70/140 MHz)

 

CDM-710

 

 

 

CRS-280L IF Switch (L-Band)

 

CDM-710G

 

 

 

 

 

 

 

 

 

 

 

 

CRS-280 IF Switch (70/140 MHz)

 

SLM-5650/5650A

 

CRS-280L IF Switch (L-Band)

 

 

 

CRS-350 ESC Switch (IDR Overhead)

Compatibility Notes:

1.The CDM-625 Open Network Satellite Modem, with its available CDM-600 Emulator Mode, serves as an operationally transparent replacement unit for the CDM-600/600L Open Network Satellite Modems.

2.The CiM-25, Comtech EF Data’s low-cost Internet Protocol (IP) Monitor & Control (M&C) interface for existing CEFD modems, is not compatible for use on modems operating within a CRS-300 redundancy system. Taking this prohibition of use under further consideration, the CiM-25 should not, under any circumstances, be connected to the Remote port on the CRS-300’s CRS-230 Controller card for control of the Switch and modems.

1–4

Page 26
Image 26
Mocomtech operation manual CRS-300 Compatibility Table