Mocomtech CRS-300 operation manual Parameter Type Code Qualifier, Rne?

CRS-300 1:10 Redundancy Switch Remote Control

Revision 16 MN/CRS300.IOM

	Command
Parameter Type	(Code and
	qualifier)
Retrieve Next 5	N/A
unread Stored
Events

Arguments for

Command or Response to Query

80 bytes

Description of Arguments

(Note that all arguments are ASCII numerical codes,

that is, ASCII codes between 48 and 57)

Query only.

Switch returns the oldest 5 Stored Events, which have not yet been read over the remote control.

Reply format: [cr]Sub-body[cr]Sub-body[cr]Sub-body[cr]Sub-body[cr]Sub- body, where Sub-body = KLMddmmyyhhmmss

K is the fault/clear indicator, where F = Fault, C = Clear, I = Info

L is the faulting/clearing unit, where the values can be: 1,2,...9 indicating traffic modems 1,2...9, A=modem 10,

B=Redundant Modem C=Switch

D=Info

M is the fault code, where value depends on faulting unit: Switch codes are 1 to F, indicating the position (1-15) of

the fault within the Switch FLT string. Modem codes are:

1= Unit, 2= Rx traffic, 3= Tx traffic Info codes are:

0= Power off, 1= Power on, 2= Log cleared

ddmmyy is the date of the event (international format). hhmmss is the time of the event.

If there are no new events, the unit replies with RNE*.

If fewer than 5 events remain, the last positions are filled with zeroes.

Response to Command (Target-to-Controller)

N/A

	Query		Response to query
	(Code and
			(Target-to-Controller)
	qualifier)
RNE?		RNE=[cr]KLMddmmyyhh
		mmss[cr]KLMddmmyyhh
		mmss[cr]KLMddmmyyhh
		mmss[cr]KLMddmmyyhh
		mmss[cr]KLMddmmyyhh
		mmss
		(see Description of
		Arguments)

Restore Holdoff	RSH=	2 bytes, numerical
Time

Command or Query.

The restore holdoff time is the delay when auto mode prepares to return a modem (previously faulted, now good) back online due to a different Traffic Modem’s failure, where:

01-99 = # of seconds after offline Traffic Modem lost its fault before it is put back online so that Redundant Modem can bridge the newly faulted modem.

RSH= (message OK)

RSH? (received OK, but invalid arguments found)

RSH# (message OK, # (message OK, but only permitted in Remote mode)

RSH?	RSH=xx
	(see Description of
	Arguments)

C–11