Mocomtech CRS-300 Parameter Type Code Qualifier Switch Alarm, SAM=x, Example SDT=1

CRS-300 1:10 Redundancy Switch Remote Control

Revision 16 MN/CRS300.IOM

	Command
Parameter Type	(Code and
	qualifier)
Switch Alarm	SAM=
Mask

Arguments for

Command or Response to Query

1 byte, numerical

Description of Arguments

(Note that all arguments are ASCII numerical codes,

that is, ASCII codes between 48 and 57)

Command or Query.

Where x indicates the Switch alarm mask: 0 = no faults masked

1 = PSU-A faults masked

2 = PSU-B faults masked

Response to Command (Target-to-Controller)

SAM= (message OK) SAM? (received OK, but invalid arguments found) SAM# (message OK, but only permitted in Remote mode)

Query	Response to query
(Code and
	(Target-to-Controller)
qualifier)
SAM?	SAM=x
	(see Description of
	Arguments)

SwitchDataTime SDT= 1 byte, numerical

Switch Global	SGC=	29 bytes,
Configuration		numerical

Switch ID SID= 24 bytes, ASCII

Command or Query.

This command allows the Switch to send commands to all attached modems on a daily basis to set their time and date values to the same as the Switch. This value is also saved in nonvolatile memory to retain setting during a power outage. The factory default setting is SDT=0.

SwitchDataTime, where x where:

0 turns off this feature.

1 enables this feature

Example: SDT=1

Command or Query.

Global configuration of the Switch, in the form: OaaaaaaaaaaBNNbbrrMSAssssssss, where: O = Operating Mode – same as OPM (1 bytes) a = Active Modems – same as ACT (10 bytes)

B = Bridge/Backup State – same as BBU (1 byte) N = Selected TM Number - same as BBU (2 bytes) b = Backup Holdoff Time – same as BKH (2 byte) r = Restore Holdoff Time – same as RSH (2 byte) M = Modem Alarm Mask – same as MAM (1 byte) S = Switch Alarm Mask – same as SAM (1 byte) A = Audio Alarm Mask – same as AAM (1 bytes) P = Priority mode – same as PRI

s = 7 spare bytes

Command or Query.

A user-defined Switch ID, which is a fixed length of 24 characters.

Valid characters include: Space ( ) * + - , . / 0-9 and A-Z.

SDT= (message OK) SDT? (received OK, but invalid arguments)

SDT* (message OK, but not permitted in current mode)

SGC= (message OK) SGC? (received OK, but invalid arguments found) SGC# (message OK, but only permitted in Remote mode)

SID= (message OK)

SID? (received OK, but invalid arguments found)

SID# (message OK, but only permitted in Remote mode)

SDT?	SDT=xx
	(see Description of
	Arguments)

SGC?	SGC=OaaaaaaaaaaBNN
	bbrrMSAPsssssss
	(see Description of
	Arguments)

SID?	SID=xxxxxxxxxxxxxxxxx
	xxxxxxx
	(see Description of
	Arguments)

C–12