Mocomtech CRS-300 RMI Card Configuration Reference, RMI JMP1 Factory-configured Jumper Settings

CRS-300 1:10 Redundancy Switch	Revision 16
Modem, RMI/TMI, and Switch Configuration	MN/CRS300.IOM

5.3RMI Card Configuration Reference

The RMI Card Configuration Reference is provided for RMI identification purposes only. All RMI cards are shipped pre-configured and do not require

IMPORTANT adjustments by the user.

The CRS-305, CRS-306, and CRS-307 RMI cards come pre-configured for proper operation. All three cards share a common printed circuit board (CEFD P/N PC/11494x); what distinguishes the cards from one another is the configuration of front panel connectors, and configuration of the JMP1 jumper setting on the PCB.

Figure 5-3shows the PCB used for all three RMIs, with the typical JMP1 jumper location identified.

Jumper JMP1

Front view Side view

Figure 5-3. CEFD P/N PC/11494x RMI PCB (CRS-307 shown)

Table 5-1illustrates the JMP1 jumper settings, as established at the factory for each RMI card.

Table 5-1. RMI JMP1 Factory-configured Jumper Settings

‘JMP1’ Jumper Setting – AS SHIPPED

CRS-305

(No jumpers)

CRS-306

(Pins 1 to 2 jumped)

CRS-307

(Pins 3 to 4 jumped)

5–10