Mocomtech CRS-300 operation manual Info Remcont Remote Control Info, Info Mask Alarm Mask Info

CRS-300 1:10 Redundancy Switch	Revision 16
Front Panel Operation	MN/CRS300.IOM

7.5.5 INFO: REMCONT (Remote Control Info)

REM CNTL:	ON	RS232
ADDR:0000	9600 BAUD 8N1

This screen displays if the unit is in LOCAL or REMOTE mode, gives details of the electrical interface type, the unit address, the baud rate, and data format. Press [ENT] to return to the previous menu.

7.5.6 INFO: MASK (Alarm Mask Info)

ALARMS MASKED: MODEM-TX

MODEM-RX ËPSU-A PSU-BÌ

This screen displays the alarms that are currently masked. If an alarm is not masked, a blank is displayed in the relevant screen position. Power Supplies A and B cannot be both masked at the same time, but are shown together here to indicate their relative positions on the screen.

7.6SELECT: MONITOR

MONITOR: STATUS SW-ALARM

STORED-EVENTS COMMS IO

Select STATUS, SW-ALARM, STORED EVENTS, COMMS or IO using the ◄ ► arrow keys, then press [ENT].

7.6.1 MONITOR: STATUS

TM 02 IS BRIDGED BY RM

BACKUP HOLDOFF: 05 SEC

This display shows the bridged or backup status of the Switch. When the Redundant Modem is not backing up any of the Traffic Modems, the display will show which Traffic Modem is currently being bridged by the Redundant Modem. If Auto mode is on, it will also show the backup holdoff- time should the bridged Traffic Modem fail. If Auto mode is off, the second line displays “OFF”. When the Switch has taken the bridged Traffic Modem offline and replaced it with the Redundant Modem (whether done manually or automatically), the display changes as follows:

TM 02 IS BACKED UP BY RM

RESTORE HOLDOFF: 05 SEC

The Restore Holdoff time is shown on the second line if Auto mode is on.

7–14