CRS-300 1:10 Redundancy Switch

Revision 16

Ethernet Network Configurations

MN/CRS300.IOM

3.3.7 Hub-to-Remotes, Split-path Traffic using Switches (Point-to-Multipoint)

With switches used, the hub and remote are on the same subnet as shown in Figure 3-13, meaning that broadcasts will be allowed to transverse the network. Learning Mode must be disabled on the Hub Tx/Rx modem, because if a computer on the remote sends a broadcast out to the Hub, the modem learns that MAC is local – when in fact it is not.

Figure 3-13. Point-to-Multipoint using Switches

Awired-thru Ethernet redundancy example is shown in Figure 3-14. When the CRS-300 1:10 Redundancy Switch backs-up a faulted Traffic Modem, the physical port on the Switch does not change, because the Ethernet connection is properly rerouted within the CRS-300 from the Traffic Modem to the Redundant Modem.

Awired-around Ethernet redundancy example is shown for the CDM-700 User in Figure 3-15. When the CRS-300 1:10 Redundancy Switch backs-up a faulted Traffic Modem, the Switch will learn the new MAC address of the redundant unit and traffic will be passed again. This type of architecture will slow down the switching time, because the Switch will need to re-learn the correct port connection.

3–12

Page 58
Image 58
Mocomtech CRS-300 operation manual Point-to-Multipoint using Switches