CRS-300 1:10 Redundancy Switch

Revision 16

Installation

MN/CRS300.IOM

or on top of the rack. If using the CRS-280L, refer also to the associated CRS-280L 1:N Redundancy Switch Installation and Operation Manual (MN/CRS280L.IOM) for further rack mounting information. The CRS-350 mounts to the back of the rack. The mounting hardware allows the user to hinge the unit down to access the data cables in the rear of the unit to connect the cables to the modems. Mount all Switches and modems in the rack as necessary.

Do not allow the internal rack temperature to exceed 50°C (122° F).

IMPORTANT

It is important to ensure that there is adequate clearance for ventilation in the rack. Since the Switch itself is relatively passive, no additional clearance is needed between it and the nearest modem. In rack systems where there is high heat dissipation, provide forced-air cooling by installing top- or bottom-mounted fans or blowers.

Figure 2-1. Typical Rack Mounting Configuration

2–2

Page 46
Image 46
Mocomtech CRS-300 operation manual Typical Rack Mounting Configuration