CRS-300 1:10 Redundancy Switch

Revision 16

Front Panel Operation

MN/CRS300.IOM

7.3SELECT (Top-Level) Menu

SELECT: CONFIG INFO

MONITOR STORE/LD UTIL

Move the cursor to the desired choice using the ◄ ► arrow keys, then press [ENT]. The following table describes the function of each menu branch (along with the section in this chapter that provides information on that branch and its accompanying submenus):

Selection

CONFIG

INFO

MONITOR

STORE/LD

UTIL

Sect.

Menu Branch Description

7.4

(Configuration) Permits the User to fully configure the Switch.

 

7.5

(Information) Permits the User to view information on the Switch, without

having to go into configuration screens.

 

 

 

7.6

Permits the User to monitor the status of the Switch and view the log of

stored events for both the Switch and its attached modems.

 

 

 

7.7

(Store/Load) Permits the User to store and to retrieve up to 10 different

Switch configurations.

 

 

 

7.8

(Utility) Permits the User to perform miscellaneous functions,

such as

setting the Real-time clock, adjusting the display brightness, etc.

 

 

 

7.4SELECT: CONFIG (Configuration)

CONFIG: MANUAL AUTO[OFF]

OPTIONS REMOTE ACTIVE

Move the cursor to the desired choice using the ◄ ► arrow keys, then press [ENT]. The submenus available under the CONFIG menu branch are as follows:

Selection

MANUAL

AUTO

[OFF/ON]

OPTIONS

REMOTE

ACTIVE

Sect.

Submenu Description

7.4.1

Permits the User to select which traffic MODEM the Switch should bridge

or backup.

 

7.4.2

Permits the User to turn Auto mode off or on. The currently selected state

is always shown on this menu

 

 

Permits the User to set several operating parameters of the Switch that

7.4.3

pertain to enabling or disabling the availability of Traffic Modems, the

 

reporting of faults and time delays for responding to faults.

7.4.4

Permits the User to define the remote control settings.

7.4.5

Permits the User to activate modems, if a TMI is present.

IMPORTANT

The Switch may be monitored over the remote control bus at any time. When in Local mode, however, configuration parameters may only be changed through the front panel. Conversely, when in Remote mode, the unit may be monitored from the front panel, but configuration parameters via may only be changed remote control bus.

7–7

Page 187
Image 187
Mocomtech CRS-300 Select Top-Level Menu, Select Config Configuration, Selection, Sect Menu Branch Description