12Additional information

Specifications

Amplifier section

Continuous average power output of 120 watts* per channel, min., at 8 ohms, from 20 Hz to 20 000 Hz with no more than 0.2 %** total harmonic distortion (front).

Continuous Power Output (20 Hz to 20 kHz, 8 , 0.2 %)

Front. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 120 W + 120 W Center . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 120 W Surround . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 120 W + 120 W Surround back . . . . . . . . . . . . . . . . . . . . . . . . 120 W + 120 W

Continuous Power Output (1 kHz, 6 , 1.0 %)

Front. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 120 W + 120 W Center . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 120 W Surround . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 120 W + 120 W Surround back . . . . . . . . . . . . . . . . . . . . . . . . 120 W + 120 W

Total harmonic distortion . . . . . . . . . . . . . . . . . . . . . . . .0.2 % (20 Hz to 20 kHz, 120 W, 8 )

*Measured pursuant to the Federal Trade Commission’s Trade Regulation rule on Power Output Claims for Amplifiers

**Measured by Audio Spectrum Analyzer

Audio Section

Input (Sensitivity/Impedance)

LINE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 335 mV/47 kFrequency Response (LINE) . . . . . . 5 Hz to 100 000 Hz dB Output (Level/Impedance)

REC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 335 mV/2.2 kTone Control

BASS . . . . . . . . . . . . . . . . . . . . . . . . . . . . ± 6 dB (100 Hz) TREBLE . . . . . . . . . . . . . . . . . . . . . . . . . . ± 6 dB (10 kHz) LOUDNESS . . . . . . . . . . +4 dB / +2 dB (100 Hz/10 kHz)

(at volume position –40 dB)

Signal-to-Noise Ratio (IHF, short circuited, A network)

LINE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .103 dB Signal-to-Noise Ratio [EIA, at 1 W (1 kHz)]

LINE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .83 dB

FM Tuner Section

Frequency Range . . . . . . . . . . . . . . . . . 87.5 MHz to 108 MHz Usable Sensitivity . . . . . . . Mono: 13.2 dBf, IHF (1.3 µV/75 ) 50 dB Quieting Sensitivity . . . . . . . . . . . . . . . Mono: 20.2 dBf Stereo: 38.6 dBf Signal-to-Noise Ratio . . . . . . . . . . . . Mono: 73 dB (at 85 dBf) Stereo: 70 dB (at 85 dBf)

Distortion . . . . . . . . . . . . . . . . . . . . . . . .Stereo: 0.5 % (1 kHz) Alternate Channel Selectivity . . . . . . . . . . . . 60 dB (400 kHz) Stereo Separation . . . . . . . . . . . . . . . . . . . . . . . . 40 dB (1 kHz) Frequency Response . . . . . . . . . . . . . 30 Hz to 15 kHz ± 1dB Antenna Input . . . . . . . . . . . . . . . . . . . . . . . .75 unbalanced

AM Tuner Section

Frequency Range . . . . . . . . . . . . . . . . . . 530 kHz to 1700 kHz Sensitivity (IHF, Loop antenna) . . . . . . . . . . . . . . . . 350 µV/m Selectivity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25 dB Signal-to-Noise Ratio . . . . . . . . . . . . . . . . . . . . . . . . . . . 50 dB Antenna . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Loop antenna

Miscellaneous

Power Requirements . . . . . . . . . . . . . . . . . . . AC 120 V, 60 Hz Power Consumption . . . . . . . . . . . . . . . . . . . . . 490 W, 650 VA In standby . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.5 W AC Outlet . . . . . . . . . . . . . . . . . . . . . . (switched) 100 W MAX. Dimensions . . . . . . 420 (W) mm x 173 (H) mm x 466 (D) mm

(16 9/16 (W) in. x 6 13/16 (H) in. x 18 3/8 (D) in.) Weight (without package) . . . . . . . . . . . .15.0 kg (33 lbs 1 oz)

Furnished Parts

Setup microphone (for Auto MCACC setup) . . . . . . . . . . . . 1 AA/IEC R6P dry cell batteries . . . . . . . . . . . . . . . . . . . . . . . 2 Remote control unit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 AM loop antenna. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 FM wire antenna . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Warranty card . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 These operating instructions

Note

Specifications and the design are subject to possible modifications without notice, due to improvements.

Composite Video / S-Video Section

Input (Sensitivity/Impedance) . . . . . . . . . . . . . . . .1 Vp-p/75 Output (Level/Impedance) . . . . . . . . . . . . . . . . . . .1 Vp-p/75 Signal-to-Noise Ratio . . . . . . . . . . . . . . . . . . . . . . . . . . . .65 dB Frequency Response . . . . . . . . . . . . . . . . . . . . 5 Hz to 10 MHz

Component Video Section

Input (Sensitivity/Impedance) . . . . . . . . . . . . . . . .1 Vp-p/75 Output (Level/Impedance) . . . . . . . . . . . . . . . . . . .1 Vp-p/75 Signal-to-Noise Ratio . . . . . . . . . . . . . . . . . . . . . . . . . . . .65 dB Frequency Response . . . . . . . . . . . . . . . . . . . 5 Hz to 100 MHz

Cleaning the unit

Use a polishing cloth or dry cloth to wipe off dust and dirt.

When the surface is dirty, wipe with a soft cloth dipped in some neutral cleanser diluted five or six times with water, and wrung out well, and then wipe again with a dry cloth. Do not use furniture wax or cleansers.

Never use thinners, benzine, insecticide sprays or other chemicals on or near this unit, since these will corrode the surface.

66

En

Page 66
Image 66
Pioneer VSX-1016TXV-K operating instructions Additional information Specifications, Cleaning the unit

VSX-1016TXV-K specifications

The Pioneer VSX-1016TXV-K is a versatile and powerful A/V receiver that brings a wealth of features and technologies to enhance your home entertainment experience. Built with the audiophile in mind, it combines high-performance sound quality with modern connectivity and smart functionality.

One of the main features of the VSX-1016TXV-K is its robust amplification system, which delivers an impressive 7.1-channel surround sound experience. With a total output of 110 watts per channel, this receiver is capable of driving a variety of speakers, ensuring that every audio detail is crisp and immersive. This makes it an ideal choice for both movie watchers and music enthusiasts.

The receiver supports numerous audio formats, including Dolby TrueHD and DTS-HD Master Audio, providing lossless audio quality for high-definition content. This commitment to audio excellence is complemented by its use of advanced technologies such as the Pioneer MCACC (Multi-Channel Acoustic Calibration System), which automatically adjusts the receiver's settings based on the acoustics of your room, ensuring optimal sound performance.

In terms of connectivity, the VSX-1016TXV-K is equipped with multiple HDMI inputs, which support 1080p video pass-through and are compatible with the latest HDMI standards. This makes it easy to connect various devices such as Blu-ray players, gaming consoles, and streaming devices, allowing seamless switching between sources. The unit also includes component and composite video inputs, as well as optical and coaxial digital audio inputs for greater flexibility.

Additionally, the receiver features an integrated AM/FM tuner, allowing listeners to enjoy their favorite radio stations. The user-friendly on-screen display and menu system enable easy navigation through different settings and offers access to a wide range of features, including preset equalizer settings and listening modes.

The VSX-1016TXV-K is designed with aesthetics in mind, featuring a sleek black finish that fits well in any home theater environment. Its robust build quality ensures durability while providing an attractive addition to your audio setup.

In conclusion, the Pioneer VSX-1016TXV-K A/V receiver stands out in the crowded market of home audio equipment with its exceptional sound performance, extensive connectivity options, and thoughtful user features. Whether you're hosting movie nights or enjoying your favorite music, this receiver delivers an impressive and engaging listening experience.