Pioneer VSX-1016TXV-K operating instructions Multi OPE, Shift, Source, Mute, Effect/Ch Sel

Controls and displays

7 TV CONTROL buttons

These buttons are dedicated to control the TV assigned to the TV CTRL button. Thus if you only have one TV to hook up to this system assign it to the TV CTRL input source button. If you have two TVs, assign the main TV to the TV CTRL button (see page 51 for more on this).

TV – Use to turn on/off the power of the TV.

TV VOL +/– – Use to adjust the volume on your TV.

INPUT SELECT – Use to select the TV input signal.

TV CH +/– – Use to select channels.

8 Component control buttons

The main buttons ( , , etc.) are used to control a component after you have selected it using the input source buttons.

The controls above these buttons can be accessed after you have selected the corresponding input source button (for example DVD, DVR1 or TV). The following controls can be accessed when listening to the built-in tuner:

MPX – Switches between stereo and mono reception of FM broadcasts. If the signal is weak then switching to mono will improve the sound quality (page 31).

DISP – Switches between named station presets and radio frequencies (page 32).

9Receiver controls

THX – Press to select a Home THX listening mode (page 27).

STANDARD – Press for Standard decoding and to switch between the various 2Pro Logic IIx and Neo:6 options (page 26).

ADV.SURR – Use to switch between the various surround modes (page 27).

STEREO – Switches between direct and stereo playback. Direct playback bypasses the tone controls and any other signal processing for the most accurate reproduction of a source (page 28).

AUTO SURR – Selects Auto Surround (Auto playback on page 26).

ACOUSTIC EQ – Press to select an Acoustic Calibration EQ setting (page 28).

SIGNAL SEL – Use to select an input signal (page 29).

10MULTI OPE

Use this button to perform multi operations (page 53).

11 SHIFT

Press to access the controls outlined in white boxes (for

example, INPUT SELECT ), or to display the currently

selected input source in the remote control LCD.

12 SOURCE

Press to turn on/off other components connected to the receiver (see page 51 for more on this).

04

13 Character display (LCD)

This display shows information when transmitting control signals.

The following commands are shown when you’re setting the remote to control other components (see Controlling the rest of your system on page 51):

SETUP – Indicates the setup mode, from which you choose the options below.

PRESET – See Selecting preset codes directly on page 51.

LEARNING – See Programming signals from other remote controls on page 51.

MULTI OP – See Multi Operation and System Off on page 53.

SYS OFF – See Multi Operation and System Off on page 53.

DIRECT F – See Direct function on page 53.

ERASE – See Erasing one of the remote control button settings on page 52.

RESET – See Resetting the remote control presets on page 52.

READ ID – See Confirming preset codes on page 52.

14 RECEIVER

Switches the remote to control the receiver (used to select the green commands above the number buttons (ANALOG ATT, etc)). Also use this button to set up surround sound (page 8, page 33).

15 VOL +/–

Use to set the listening volume.

16 MUTE

Mutes the sound or restores the sound if it has been muted (adjusting the volume also restores the sound).

17EFFECT/CH SEL

Press repeatedly to select a channel, then use +/– to adjust the level (see Tip on page 38). Also adjusts the level of the Advanced Surround effects, Dolby Pro Logic IIx Music, and Neo:6 Music parameters (page 27). You can then use the +/– buttons to make these adjustments.

25

En