Pioneer VSX-1016TXV-K operating instructions Using multi operations, Using System off

11Controlling the rest of your system

7Select the button for the command you want to input.

The following remote control commands can be selected:

RECEIVER	INPUT		SYSTEM OFF
			SOURCE
	SELECT
					TV CONTROL
				TVVOL	INPUT	TVCH	VOL
		DVR 2			SELECT
DVD	TV	DVR1	TVCTRL
		XM RADIO		DTVON/OFF	REC	DTV INFO
CD	CD-R	TUNER	RECEIVER				MUTE
				MPX		REC STOP	JUKEBOX
	SLEEP	SBch	ANALOG
			ATT
	SR+	DIMMER	MIDNIGHT/	AUDIO	SUBTITLE	HDD	DVD
				DISP		CH	CH
			LOUDNESS
	DIALOG E	PHASE	S.RETRIEVER	THX	STANDARD	ADV.SURR	STEREO
D.ACCESS +10			CLASS DISC	MULTI OPE	AUTOSURR ACOUSTIC EQ		SIGNAL SEL
			ENTER
				SHIFT	EFFECT/CHSEL
TOPMENU			MENU
	TUNE
DTVMENU	ST	ST	T.EDIT
SETUP	ENTER		RETURN
GUIDE CATEGORY TUNE					RECEIVER
		BAND

•You don't need to program the receiver to switch on or off. This is done automatically.

With Pioneer components, you don’t need to:

•program the power to switch off in a shutdown sequence (except DVD recorders);

•program the power to switch on if it’s the source component selected in step 3;

•program a Pioneer TV or monitor to switch on if the input function (selected in step 2) has video input terminals;

These take priority in multi operations (not shutdown).

8Repeat steps 5–7 to program a sequence of up to five commands.

9 When you’re finished, use	to select EDITEXIT
from the menu and press ENTER.

You will return to the remote control SETUP menu. Select

*EXIT * again to exit.

Using multi operations

You can start multi operations with the receiver switched on, or in standby.

AUDIO SUBTITLE	HDD	DVD
DISP	CH	CH

THX STANDARD ADV.SURR STEREO

MULTI OPE AUTOSURR ACOUSTIC EQ SIGNAL SEL

SHIFT EFFECT/CHSEL

RECEIVER

1 Press MULTI OPE.

MULTI OP flashes in the display.

2Press an input source button that has been set up with a multi operation.

The receiver switches on (if it was in standby) and the programmed multi operation is performed automatically.

Using System off

			AUDIO	SUBTITLE	HDD	DVD
		SYSTEM OFF	DISP		CH	CH
RECEIVER	INPUT
		SOURCE	THX	STANDARD	ADV.SURR	STEREO
	SELECT
			MULTI OPE	AUTOSURR ACOUSTIC EQ		SIGNAL SEL
			SHIFT	EFFECT/CHSEL

DVR 2

RECEIVER

DVD TV DVR1 TVCTRL

1 Press MULTI OPE.

MULTI OP flashes in the display.

2 Press SOURCE .

The command sequence you programmed will run, then

all Pioneer components will switch off1, followed by this receiver.

Note

1 In order to avoid accidently switching off a DVD recorder that is currently recording, no DVD recorder power off codes are sent.

54

En