Toshiba VF-A7 instruction manual Pattern run, Title Function Adjustment range Default Setting

6.24 Pattern run

 ：Pattern run selection

 ：Pattern run mode

 ,  ,  ,  ：Cycle number of pattern group #1 to #4

 ～  ：Pattern group #1 selection #1～#8

 ～  ：Pattern group #2 selection #1～#8

 ～  ：Pattern group #3 selection #1～#8

 ～  ：Pattern group #4 selection #1～#8

 ～  ：Preset-speed #1～#15 operation continuation mode

 ～  ：Preset-speed #1 to #15 operation time

・Function

These parameters enable you to form up to 60 patterns of automatic operation by variously combining operation frequencies, operation times and acceleration/deceleration times.

1)Start-up by control panel operation(＝) : up to 15 patterns

2)Start-up by terminal board operation(＝): up to 60 patterns (15 types x 4 patterns)

Note) When control is exercised by the operation panel, pattern group #1 is always selected. If you want to operate in a pattern other than pattern group #1, select pattern group #1, #2, #3 or #4 , using input terminal selection parameters (～).

[Parameter setting]

Title	Function	Adjustment range	Default
			setting
	Pattern run	: Disabled, : Enabled	
	selection
	Pattern run mode	: Patterned operation canceled during stop	
		: Patterned operation continued during stop
	Cycle number of	～, : ∞	
	pattern group #1
	Pattern group #1	: Skip,  to 	～
～	selection #1～#8
	Cycle number of	1～, : ∞	
	pattern group #2
	Pattern group #2	: Skip,  to 	～,
～	selection #1～#8		
	Cycle number of	1～, : ∞	
	pattern group #3
	Pattern group #3	: Skip,  to 	～
～	selection #1～#8
	Cycle number of	1～, : ∞	
	pattern group #4
	Pattern group #4	: Skip,  to 	～,
～	selection #1～#8		
	Preset-speed	: Operation time in second after start of operation
		: Operation time in minute after start of operation
	#1～#15
		: Operation time in second after attainment of frequency
	operation		
～		: Operation time in minute after attainment of frequency
	continuation	: Infinite (continued until stop command is entered)
	mode
		: Continue until next step command
	Preset-speed	～ [s]/[min]
	#1～#15		
～		(The unit depends on )
	operation time

＊Forward/reverse, Acc/Dec time #1/#2, V/f control mode #1/#2 can be set with ～ (Preset-speed operation frequency #1 to #15 control modes). Refer to 5.14 for details.

Note) When the function of auto-restart is active, the time spent for speed search is added to the operation time set for pattern operation. Consequently, the effective operation time sometimes becomes shorter than the settled operation time.

F-54