Toshiba VF-A7 Selection of terminal functions, Changing input terminal functions

6.3 Selection of terminal functions

6.3.1 Keeping an input terminal function always active (ON)

 ：Always active function selection

・Function

This parameter is used to select a function to be kept always active (ON) from among the input terminal functions. (One function can be selected)

■Parameter setting

TitleFunction

 Always active function selection

Adjustment range

～

Default setting



※The selected function is kept always active regardless of the type of logic (positive or negative) in the table of function settings in 7.2.1.

6.3.2 Changing input terminal functions

 ：Input terminal selection #1 (F)

 ：Input terminal selection #2 (R)

 ：Input terminal selection #3 (ST)

 ：Input terminal selection #4 (RES)

 ：Input terminal selection #5 (S1) Refer to 7.2.1 for details.

 ：Input terminal selection #6 (S2)

 ：Input terminal selection #7 (S3)

 ：Input terminal selection #8 (S4)

 ～  ：Input terminal selection #9～#16

6.3.3 Signal on completion of acceleration/deceleration (OUT 2)

 ：Output terminal selection #2 (OUT2)

・Function

If this parameter is so set, a signal is put out on completion of acceleration/deceleration. ★Open collector output terminal OUT1 or OUT2 (24 Vdc - max. 50 mA)

■Setting of output terminal

	Title		Function	Adjustment range	Setting value
					: Acceleration/deceleration
			Output terminal		completion(a-contact)
				～	or
			selection #2 (OUT2)
					: Acceleration/deceleration
					completion(b-contact)
Note) OUT1 for putting out a signal, select the parameter .
	Output frequency [Hz]
			Reference
		
	(Speed reach detection band)				[s]
			０
	Acc. Completed(a-contact)				ON
					OFF
( Acc. Completed(b-contact)					ON
					OFF)

F-7