Toshiba VF-A7 Canceling PID control in panel operation mode, Override in panel operation mode

Function

6.29.10 Canceling PID control in panel operation mode

 ：Panel PID control OFF

・Function

This parameter is to switch from PID control to open-loop control (normal control mode) when PID control is exercised by the control panel.

Note) This parameter is valid only when the inverter is in panel operation mode.

：PID control enabled

PID control is exercised if  is not set at .

：PID control disabled

Open-loop control (normal control mode) is exercised instead of PID control.

[Parameter setting]

Title

Adjustment range

Default setting

	Panel PID control OFF	: ON	
		: OFF

Note) When  is set at , open-loop control is exercised even if this parameter is set at  (PID control enabled).

6.29.11 Setting a torque command in panel operation mode

 ：Panel torque reference

・Function

This parameter is to set a torque command when torque control is exercised by the operation panel. This parameter is valid only when the inverter is in control panel operation mode.

Panel operation: Torque command selection  is set at (Panel input).

[Parameter setting]

Title	Function	Adjustment range	Default setting
	Panel torque reference	～ [%]	

＊Refer to 3.3.3 for details.

6.29.12 Drooping control in panel operation mode

 ：Panel synchronized torque bias

 ：Panel tension torque bias

 ：Panel load sharing gain

6.29.13 Override in panel operation mode

 ：Panel over-ride multiplication gain

＊Refer to 6.27 for details.

F-70