Toshiba VF-A7 Changing items displayed in status monitor mode, Switching basic parameters

Title	Function	Adjustment	Default	Value displayed after
		range	setting	change (example)
	Decimal place number of	: 1 [s]		
	Acceleration/deceleration	: 0.1 [s]		
	time	: 0.01 [s]		

6.29.5 Changing items displayed in status monitor mode

 ：Monitor display mode setting

 ：Status monitor #1 display mode

 ：Status monitor #2 display mode

 ：Status monitor #3 display mode

 ：Status monitor #4 display mode

These parameters are used to select the item to be displayed when the power is turned on and also to change items displayed in status monitor mode. Refer to 8.1 for details.

6.29.6 Switching basic parameters

 ：Selection of panel V/f1, 2, 3 or 4

・Function

This parameter is used to switch V/f characteristics during operation or to drive four motors with a single inverter.

This parameter is valid only when the inverter is in panel operation mode.

[Parameter setting]

V/f1 is selected default setting.

	Title		Function			Adjustment range		Default setting
		Selection of panel			1: V/f1,		2: V/f2,		
		V/f1,2,3	or 4		3: V/f3,		4: V/f4
[Parameters which can be switched with ]
		(V/f1)					(V/f2)
Base frequency #1						Base frequency #2			
Base frequency voltage #1						Base frequency voltage #2			
Manual torque boost						Manual torque boost #2			
Motor overload protection level #1						Motor overload protection level #2			
		(V/f3)					(V/f4)
Base frequency #3						Base frequency #4			
Base frequency voltage #3						Base frequency voltage #4			
Manual torque boost #3						Manual torque boost #4			
Motor overload protection level #3						Motor overload protection level #4			

: Parameter groups selected by default

■Switching by means of terminals

The V/f1, 2, 3 and 4 can also be switched by switching on and off terminals. ⇒Refer to 6.4.1 for details.

F-68