Toshiba VF-A7 instruction manual How to set basic parameters Basic parameter

★About the parameter's adjustment range

: A value larger than the upper-limit value is entered or the value set for the currently-selected parameter becomes larger than the upper-limit value because another parameter was changed.

: A value smaller than the lower-limit value is entered or the value set for the currently-selected parameter becomes smaller than the lower-limit value because another parameter was changed.

If the above alarm code  or  blinks, change the parameter setting below the  value or above the  value, respectively. When any of these alarm codes is blinking, no change can be made to any parameter.

4.1.1 How to set basic parameters [Basic parameter]

Every basic parameters can be set in the same way.

[Procedure for setting a basic parameter]

MON		：Press this key to switch to setting
		monitor mode.
		：Press these keys to select the
▲	▼	parameter you want to change.
		：Press this key to display the
ENT		parameter setting.
		：Press these key to change the
▲	▼	parameter setting.
		：Press this key to save the change.
ENT

★The inverter is shipped with certain parameters factory-set by default.

★Use "Parameter list" to select the parameters you want to change.

★If you feel puzzled about what to do next during this operation, press the Monitor key to return to the first step ( is displayed).

Follow the procedure below to set a basic parameter.

(Example of setting: Changing the maximum frequency from 80 to 60 Hz)

Key operated			LED display			Operation
					The operation frequency is displayed. (Out of operation.)
					(If the monitor display mode setting parameter  is
					set at [Operation frequency])
	MON				Press the [MON] key to call up the first basic parameter
					 (automatic acceleration/deceleration).
▲	▼				Select "" by pressing the △ or ▽ key.
	ENT				Press the Enter key to display the changed maximum
					frequency.
▲	▼				Change the maximum frequency to 60 Hz by pressing▽
					key.
	ENT		⇔		Press the Enter key to save the change. Then,  and the
					set maximum frequency are displayed alternately.
After	this,	→ Press this key to		MON → Press this key to		▲ ▼ → Press these keys
	ENT
			display the same		switch to status	to call up other
			parameter setting.		monitor mode.	parameters.
					D-2