Invacare 1171794-B user manual Using the Proper Batteries

Page 43

3.Test personal transporter for maneuverability.

4.Readjust locknuts if necessary, and repeat STEPS 1-3 until correct.

5.Snap head tube cover into the caster head tube.

6.11 Batteries

WARNING!

– Invacare strongly recommends that battery installation and battery replacement always be done by a qualified technician.

–The use of rubber gloves is recommended when working with batteries.

–After ANY adjustments, repair or service and before use, make sure all attaching hardware is tightened securely - otherwise injury or damage may result.

–17AH batteries weigh 15 pounds each. Use proper lifting techniques (lift with your legs) to avoid injury.

–DO NOT remove the circuit breaker from the wiring assembly.

–Unless otherwise indicated, make sure power to the personal transporter is OFF before performing these procedures.

–DO NOT tip the batteries. Keep the batteries in an upright position.

–ALWAYS use a battery handle/lifting strap when lifting a battery. It is the most convenient method and assures that the battery acid will not spill.

–When tightening the clamps, always use a box wrench. Pliers will “round off” the nuts. NEVER wiggle the battery terminal(s)/post(s) when tightening. The battery may become damaged.

Setup and Maintenance

WARNING!

– NEVER allow any of your tools and/or battery cable(s) to contact BOTH battery post(s) at the same time. An electrical short may occur and serious personal injury or damage may occur.

–The POSITIVE (+) RED battery cable MUST connect to the POSITIVE (+) battery terminal(s)/post(s), otherwise serious damage will occur to the electrical system.

If there is battery acid in the bottom of the battery box or on the sides of the battery(ies), apply baking soda to these areas to neutralize the battery acid. Before reinstalling the existing or new battery(ies), clean the baking soda from the battery tray or battery(ies) being sure to avoid contact with skin and eyes. Determine source of contamination. NEVER install/reinstall a battery with a cracked or otherwise damaged case.

Using the Proper Batteries

WARNING!

– Use 17AH batteries only. Batteries with terminal configuration (positive on the left and negative on the right) as shown below MUST be used. Batteries that have the reverse terminal configuration MUST not be used - otherwise injury and damage may occur.

–Terminals must have a cross hole in them as shown below in Detail “A”.

1.Position battery on ground/flat surface as shown below.

2.Visually inspect the battery to ensure proper polarity:

1171794-B

43

Page 42 Page 44
Image 43
Page 42 Page 44
Contents Invacare ProntoAir Personal Transporter w/ MyBody Seating InvacareCorporation Contents Troubleshooting General SymbolsGeneral Guidelines Operation Information SetupStairways and Escalators Repair or Service Information Global Limited Warranty Excluding Canada1171794-B Canada Limited Warranty 1171794-B Safety/Handling Safety HandlingStability and Balance Coping with Everyday Obstacles Pinch Points Reaching, Leaning and Bending Forward FootplateTransferring To and From Other Seats Reaching, Bending BackwardStorage Electrical Batteries Electrical Grounding InstructionsElectrical Charging Batteries Weight Limitation Weight TrainingElectromagnetic Interference EMI From Radio Wave Sources Personal Transporter Electromagnetic Interference EMI Personal Transporter Electromagnetic Interference EMI Pronto Air Personal Transporter Label LocationsTypical Product Parameters Technical DataWheelchair Operation SPJ+ Joystick Switches and IndicatorsPersonal Transporter Usage Charger/Programming Input Using the Joystick to Drive the ChairService Indicator JoystickMovement Action Disengaging/Engaging Motor Lock LeversProntoAir Personal Transporter w/ MyBody Seating Removing Removing/Installing the Seat AssemblyUsing the Folding Back Assembly InstallingCharging Batteries Transporting the Personal TransporterTool Quantity Description and Use of Battery ChargersSetup/Delivery Inspection Setup and MaintenancePreparing the Personal Transporter for Use Inspect/Adjust Monthly User/Attendant Inspection ChecklistsService Inspection Inspect/Adjust WeeklyJoystick Installing the JoystickDisconnecting/Connecting the Joysticks Adjusting the Seat Assembly Height DisconnectingConnecting Adjusting the Joystick DepthAdjusting the Headrest Height Back Angle AdjustmentSeat Pan Depth Adjusting the Arm Height Adjusting Arm WidthArmrest Assemblies Adjusting the Armrest Pad Angle Left or Right Adjusting the Arm Pad DepthFootboard Adjusting the Armpad Angle Up or DownAdjusting the Footboard Angle Adjusting the Footboard HeightCleaning the Cushion Covers Adjusting ForksRemoving/Installing the Seat Cushion Cover Removing/Installing the Back Cushion CoverBatteries Using the Proper BatteriesReplacing the Batteries Working with batteries Disconnecting/Connecting the Battery CablesResetting the Circuit Breaker Cleaning Battery TerminalsDriving Performance TroubleshootingElectrical Information Gauge DiagnosticsDON’T Checking Battery Charge LevelYES Usability SurveyPage Making Life’s Experiences Possible

1171794-B specifications

The Invacare 1171794-B is a versatile mobility aid designed to enhance the independence and comfort of users needing assistance with mobility. This product is particularly well-suited for individuals with varying levels of mobility challenges, ensuring safety and ease of use in a range of environments.

One of the main features of the Invacare 1171794-B is its lightweight aluminum frame. This construction not only makes the product easy to maneuver, but also adds to its durability. The frame is designed to withstand regular use, ensuring a long lifespan even under demanding conditions.

Another significant characteristic of the Invacare 1171794-B is its adjustable height feature, which allows users to customize the chair according to their personal comfort needs. This adjustability is essential for maintaining ergonomic support and reducing the risk of strain during use. The chair accommodates various user heights, making it a suitable option for a wide audience.

The Invacare 1171794-B is equipped with comfortable, padded armrests and a supportive seat, designed for prolonged use without discomfort. The upholstery is easy to clean, providing convenience for daily maintenance. Additionally, the chair features a safety brake system that ensures stability when the user is getting in or out of the chair, thus prioritizing safety.

Furthermore, the Invacare 1171794-B is designed with easy maneuverability in mind. Its compact design allows it to navigate through tight spaces effortlessly, whether that's within a home or in larger public locales. The smooth-rolling wheels come with a locking mechanism, ensuring that the chair remains stable in stationary positions.

The product also includes a foldable design, making transportation and storage straightforward. This folding capability is beneficial for users who need to travel frequently or have limited storage space at home.

In summary, the Invacare 1171794-B provides an ideal combination of comfort, safety, and convenience, making it an excellent choice for those seeking reliable mobility support. Its innovative features and thoughtful design position it as a valuable asset for enhancing the quality of life for users and caregivers alike.
Top Page Image Contents