Before You Begin
Remove contents from box. Remove the foam separators that protect the components from damage during shipping. Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have occurred during shipping. Because the scooter was 95 percent assembled and packed at the factory, there should not be any problems, even if the box has a few scars or dents.
MAKE SURE POWER SWITCH IS TURNED “OFF” BEFORE CONDUCTING ANY MAINTENANCE PROCEDURES.
Estimated Assembly and Set-Up Time
Razor recommends assembly by an adult with experience in bicycle mechanics. Allow up to 20 minutes for assembly, not including initial charge time.
Allow up to 18 hours for initial charge (see page 3 for charging information)
Charger | Brake Lever |
| Charger |
| Port |
Charger | Twist Grip Throttle |
Plug |
Handlebar
Stem
Push Button
Quick Release
On/off switch
Reset button
Charger port
Limiter
-Battery 
-Motor
-Control Module
Required Tools
2.5mm / 6mm key wrench | 8mm, 10mm, 13mm and | Screwdriver | |
(Included) | 17mm wrenches | (Included) | for Schrader valve tires, |
| (Included) |
| with pressure gauge |
|
|
| (Not included) |
WARNING: DO NOT USE NON- RAZOR PRODUCTS WITH YOUR RAZOR ELECTRIC SCOOTER. The scooter has been built to certain Razor design specifications. The original equipment supplied at the time of sale was selected on the basis of its compatibility with the frame, fork and all other parts. Certain aftermarket products may or may not be compatible.
Need Help? Visit our web site for replacement parts, product support and a list of authorized service centers at www.razor.com or call toll free
2