Razor E175 owner manual Chain and Rear Tire Replacement

Repair and Maintenance

qChain and Rear Tire Replacement

Tools required: Phillips screwdriver, 10mm wrench, two (2) 8mm wrenches, and two (2) 13mm wrenches.

1 With a Phillips screwdriver, loosen the two screws and remove the chain guard.

2 With a 10mm wrench, loosen both axle adjusters an equal amount, approximately five turns.

3With two 13mm wrenches, loosen the axle. Slide the wheel forward to loosen the chain.

4Remove wheel.

Note the sequence of the hardware:

Right Side (Throttle)		Left Side (Brake)
18-1 M8 Nut		18-1 M8 Nut
18-2 Washer		18-2 Washer
18-3	Axle adjuster eye bolt	18-3	Axle adjuster eye bolt
18-4 U Piece		18-4 U Piece
18-5 M6 Locknut		18-5 M6 Locknut
18-6 Cap		18-6 Cap
18-7	Plate cut washer	18-7	Plate cut washer
18-8	Thick cut washer	18-8	Thick cut washer
18-9	(Short) spacer	18-9	(Long) spacer

18-1

18-2 18-3 18-7

18-8

18-11

18-4		18-10
18-5		18-9
18-6
		18-8
		18-7
		18-3
	18-4	18-2
		18-1
	18-5
	18-6

5 Install new chain or wheel by maneuvering the chain onto the sprocket and slipping the axel into the slots on the frame.

6 Install the axle adjusters and axle nuts. Tighten until they just barely hold the hardware in place.

7 Tighten both axle adjusters the same number of turns to fine-tune the tension on the chain and center of the wheel.

8 Replace the chain guard.

Need Help? Visit our web site for replacement parts, product support and a list of authorized service centers at www.razor.com or call toll free 866-467-2967 Monday - Friday 8AM - 5PM Pacific Time.

6