P 10/17
Repair
[3]DISASSEMBLY/ASSEMBLY
[3]-6. Handle Section
DISASSEMBLY
Handle section consists of the following main parts: Handle base, Handle, Handle cover
And it can be disassembled as illustrated in Figs. 17 - 20.
Fig. 17 | Fig. 18 |
1.Separate Handle section from the machine first by removing the four screws illustrated below, then by disconnecting Connector housing of Controller from Motor housing; Compression spring 14 can be removed from Crank housing in this step.
Compression spring 14
Handle section
M5x20 Pan head screw (2 pcs)
Connector housing 
of Controller
5x25 Tapping screw (2 pcs)
2.Remove Handle cover and Spring guide from Handle base.
4x18 Tapping screw (2 pcs)
Spring guide
Handle base
Handle
Handle cover
4x18 Tapping screw (1 pc)
Fig. 19
3.Separate Handle from Handle base.
Note: See Fig. 10 for disassembling the electrical parts in Handle section.
Handle base
Dust cover support
Dust cover
Handle
Shoulder sleeve 6 (2 pcs)
5x25 Tapping screw (2 pcs)
ASSEMBLY
Do the reverse of the disassembling steps.
Fig. 20
4.Remove Switch lever and Stop ring
Compression spring 8
Stop ring
Switch Lever