Makita HK1820 dimensions 17/17

Page 17

P 17/17

Wiring diagram

[3] Connecting Connector Housing with Brush Holder Unit

Connector housing is directional when connected with Brush holder complete in Motor housing. Be sure to connect as described in Fig. D-6.

Fig. D-6

The side where Lead wires are drawn out must be placed on Rear cover side as illustrated blow.

Connector housing B

 

(if used)

Connector housing A

Motor housing

 

 

Choke coil

 

(if used)

 

to Controller

 

on Handle base

side where Lead wires are drawn out

Rear cover

[DO NOTs]

1. The side where Lead wires are drawn out must not be placed on the opposite side to Rear cover.

2. Do not put Lead wires on Connector housing(s) or Lead wires will be pinched between Handle base and Motor housing.

Image 17
Contents Standard equipment SpecificationOptional accessories Repair Necessary Repairing ToolsChuck Section DISASSEMBLY/ASSEMBLYBarrel, Tool Holder, Cylinder Section After removing O Ring 26, the following parts Electrical Parts in Handle Section AssemblyMotor Section DISASSEMBLY/ASSEMBLY Gear Crank Section Handle Handle SectionRecommended Fastening Torque of Screws and Bolts Maintenance ProgramCircuit diagram Routing Wires Through Handle Base and Handle Wiring diagram14/17 15/17 16/17 17/17