P 5/17
Repair
[3] DISASSEMBLY/ASSEMBLY
[3] -2. Barrel, Tool Holder, Cylinder Section
DISASSEMBLY
3)Separate Tool holder from Cylinder section as described in Fig. 7.
4)Disassemble Impact bolt and Cylinder section as described in Fig. 8.
Fig. 7
1.Pull out Striker from Cylinder section.
Cylinder section Striker
2.Remove ring 25, Urethane ring 26 and Ring spring 37 from Cylinder.
Ring 25
Ring spring 37
Urethane ring 26
3.By removing Ring 39, you can see Pin 6 (3 pcs) that join Tool holder with Cylinder.
Ring 39
Pin 6 (3 pcs)
4.By removing Pin 6, Tool holder can be separated from Cylinder section. Remove Rod 2.5 (3 pcs) from the grooves of Cylinder.
5.Push out Impact bolt section from Cylinder section using screwdriver.
Screwdriver, | Tool holder | |
magnetized with 1R288 | ||
| ||
Pin 6 (3 pcs) | Rod 2.5 (3 pcs) |
Impact bolt section
Cylinder section
Note: Pin 6 can be removed as described below if it is difficult to remove.
1.Apply magnetized screwdriver to Pin 6.
Screwdriver, magnetized with 1R288 
Pin 6
Tool holder |
Cylinder |
2.Align the through hole of Tool holder with that of Cylinder by pushing Tool holder.
3.Remove Pin 6 using magnetized screwdriver when the two holes are aligned.
Fig. 8
Disassembling Impact Bolt Section | Disassembling Cylinder Section | ||
|
| After removing O Ring 26, the following parts | |
Rubber ring 13 |
| can be removed from Cylinder: | |
|
| Cup washer 29, Compression Spring 32, Ring 29 | |
|
| Ring 29 | Cup washer 29 |
|
|
| |
Impact bolt | Flat washer 12 |
|
|
|
| Cylinder |
|
|
| Compression Spring 32 O Ring 26 | |