Makita HK1820 dimensions Wiring diagram, Routing Wires Through Handle Base and Handle

Page 13

P 13/17

Wiring diagram

[1] Routing Wires Through Handle Base and Handle

Be careful not to pinch the Lead wires with the ribs. (Figs. D-2,D-3)

Fig. D-2

 

Do not to put the Lead wire (clear)

Handle base

of Noise suppressor on these ribs.

 

 

Handle

Handle cover Controller

Noise suppressor (if used)

Handle base, viewed from Controller side

Through hole for passing Lead wires from Controller and Connector housing to the opposite side

Through hole for passing Grounding (Earth) wire from the opposite side

Do not put the Lead wires on this rib or they will be pinched between the rib and Handle.

Do not to put the Lead wires on these ribs or they will be pinched between the ribs and Motor housing.

Fig. D-3

Handle,

viewed from Handle cover side

Through hole for passing Lead wires to the opposite side

Do not to put the Lead wires on this rib or they will be pinched between the rib and Handle cover.

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Optional accessories SpecificationStandard equipment Repair Necessary Repairing ToolsChuck Section DISASSEMBLY/ASSEMBLYBarrel, Tool Holder, Cylinder Section After removing O Ring 26, the following parts Electrical Parts in Handle Section AssemblyMotor Section DISASSEMBLY/ASSEMBLY Gear Crank Section Handle Handle SectionRecommended Fastening Torque of Screws and Bolts Maintenance ProgramCircuit diagram Routing Wires Through Handle Base and Handle Wiring diagram14/17 15/17 16/17 17/17
Top Page Image Contents