V . C O M F O R T A D J U S T M E N T S
Armrest Width Adjustment
You can change each armrest’s width independently of the other.
To change the armrest width:
1.Locate the two adjustment knobs on the armrest receiver bracket. See figure 15.
2.Loosen the knobs.
3.Slide the armrests in or out to the desired width.
4.Tighten the knobs.
Armrest Angle Adjustment
To change the armrest angle:
1.Lift the armrest straight up so that it is perpendicular to the floor. See figure 15.
2.Loosen the jam nut.
3.Turn the adjusting screw to raise or lower the front of the armrest.
4.Tighten the jam nut to lock the adjusting screw into place.
Armrest Height Adjustment
To change the armrest height:
SETSCREW
Figure 16. Underside of Armrest
1.Loosen the two setscrews located on the armrest receiver. See figure 15.
2.Raise or lower the armrest to the desired height.
3.Tighten the setscrews to secure the armrest.
Controller Position
You can move the controller in toward or out away from the armrest, or change the position of the controller for either
MANDATORY! Prevent controller harness damage! Avoid routing the controller harness on the outside of the armrest pad. Route the harness under the armrest or toward the inside of the armrest pad. Use correct
To extend the controller:
1.Flip up the armrest so it is perpendicular to the floor.
2.Loosen the setscrew on the controller bracket. See figure 16.
3.Slide the controller into or out of the armrest to the desired position.
4.Tighten the setscrew to secure the controller.
To change the controller position:
1.Unplug the controller connector from the electronics tray. See figure 6.
2.Cut the wire tie that attaches the controller cable to the armrest.
3.Flip up the armrest so that it is perpendicular to the floor.
4.Loosen the setscrew under the armrest. See figure 16.
5.Slide the controller out of the armrest.
6.Loosen the setscrew under the other armrest.
Quantum 1402 | www.quantumrehab.com | 25 |