Quantum Quantum 1402 manual To charge the batteries using the onboard charger

Page 31

V I I . B A T T E R I E S A N D C H A R G I N G

WARNING! If your battery charger has not been tested and approved for outdoor use, then do not expose it to adverse or extreme weather conditions. If the battery charger is exposed to adverse or extreme weather conditions, then it must be allowed to adjust to the difference in environmental conditions before use indoors. Refer to the manual supplied with the battery charger for more information.

To charge the batteries using the onboard charger:

1.Position the rear of your power chair next to a standard electrical outlet.

2.Be certain the controller power is turned off and the freewheel levers are in the engaged position. See III. “Your Power Chair.”

3.Slide the rear cover forward.

4.Extend the charger power cord and plug it into the electrical outlet.

NOTE: The power chair incorporates an inhibit function that disables the power chair when the charger is plugged into an electrical outlet.

5.We recommend you charge the batteries for 8 to 14 hours. As the batteries charge, the ammeter needle slowly drops to zero.

NOTE: The ammeter indicates how much charge is needed to fully charge the batteries. Wait about a minute for the charger to warm up. The ammeter may move as high as 5.5 amps, then gradually move back down to 0 amps as the batteries charge.

6.When the batteries are fully charged, the needle vibrates on or near the zero mark on the ammeter scale. Unplug the power cord from the electrical outlet, wind it up using the hook and loop strap, and place the cord back into the electronics tray.

To charge the batteries using the off-board charger:

1.Position the front of your power chair next to a standard electrical outlet.

2.Turn off the power to the controller and engage the manual freewheel lever(s) in the drive position. See III. “Your Power Chair.”

3.Plug the 3-pin extension cable from the off-board battery charger into the off-board battery charger/program- ming socket on the controller.

4.Plug the off-board battery charger into the electrical outlet.

NOTE: If it is a Pride off-board charger, then there are two lights in it. The red light indicates that power to the off-board charger is on. The green light indicates that the batteries are fully charged. If it is not a Pride off- board charger, then follow the instructions supplied by the manufacturer.

.

5. When the batteries are fully charged, disconnect the charger from the electrical outlet, then from the controller.

Quantum 1402

www.quantumrehab.com

31

Image 31
Contents Quantum Quick Reference Information F E T Y G U I D E L I N E SIII N T E N T SShipping and Delivery SafetyN T R O D U C T I O N PURCHASER’S AgreementS a F E T Y Product Safety SymbolsS a F E T Y S a F E T Y S a F E T Y General Guidelines Pre-Ride Safety CheckModifications Tire Inflation Weight LimitationsIncline Information Braking Information Freewheel ModeCornering Information Public Streets and Roadways Outdoor Driving Surfaces Inclement Weather PrecautionsStationary Obstacles Steps, Curbs, etc Lift/Elevation Products Stairs and EscalatorsDoors ElevatorsBatteries Prescription Drugs/Physical Limitations TransfersAlcohol/Smoking Electromagnetic and Radio Frequency Interference EMI/RFI I . Y O U R P O W E R C H a I R Quantum 1402 Power ChairElectronics Tray Electronics TrayTo operate the dual manual freewheel levers Dual Manual Freewheel LeversActive-Trac Suspension Rear Suspension System Rear SuspensionSeat Installation Initial AssemblyA S S E M B L Y Power Seat Option Installation To install the seatTo install the power seat O M F O R T a D J U S T M E N T S Comfort AdjustmentsYou may need the following to make comfort adjust- ments Seat Height/Angle AdjustmentSeat Position Manual Recline Seatback AdjustmentTo adjust the seatback angle Seatback Angle AdjustmentController Position Armrest Width AdjustmentArmrest Angle Adjustment Armrest Height AdjustmentFoot Platform Depth Adjustment Foot Platform Height AdjustmentFoot Platform Angle Adjustment Evating seat, you can change the seat height auto Power Elevating Seat OptionIf your power chair is equipped with a power el Matically. The power elevating seat is operatedTo adjust the anti-tip wheels Anti-tip Wheel AdjustmentSeat Removal D I S a S S E M B L YFoot Platform Removal Batteries and Charging I . B a T T E R I E S a N D C H a R G I N GCharging The Batteries To charge the batteries using the off-board charger To charge the batteries using the onboard chargerFrequently Asked Questions FAQs Battery Break-InHow can I get maximum range or distance per charge? What type of battery should I use?Why do my new batteries seem weak? How can I ensure maximum battery life?What about public transportation? How should I store my power chair and its batteries?What about shipping? I I . C a R E a N D M a I N T E N a N C E Care and MaintenanceShould your power chair come in contact with water TemperatureMonthly Checks Daily ChecksWeekly Checks To check the brakesStorage Disposal of Your Power ChairCleaning Instructions Wheel ReplacementQuantum 1402 Drive Wheel Battery ReplacementWhen to See Your Quantum Rehab Specialist for Service To replace the batteryCorrective Maintenance W a R R a N T Y Exclusions also include components with damage caused by Reconditioned Units WarrantyWarranty Exclusions Service Checks and Warranty ServiceP E N D I X I Specification S Quantum 1402 Dimensions and Ground Clearance T E S T E S Quality Control Quantum