Sunrise Medical P-220 instruction manual I . B a t t e r i e s, Introduction, Battery Charger

Page 23

44 X I . B a t t e r i e s

A. INTRODUCTION

1.Notes–

Batteries supply the power for your chair. They contain a finite amount of energy and have limits on how long they can store and supply energy.

You can charge batteries only a certain number of times before they will fail and no longer hold a charge.

For answers to questions about batteries, consult your supplier.

2.Use Proper Batteries:

Your chair operates on two 12 volt batteries.

They should be Group 24 (or 22NF) size with a minimum of 65 ampere hour rating. Only deep cycle sealed case construction batteries should be used in this device.

Connecting configuration. They should have a post and clamp style connection.

When you buy a replacement, insist on a deep cycle sealed case type. Do not use a car starter battery.

3.Breaking In:

A battery requires “breaking-in” for the first 6 to 12 charges. It will not accept a full charge for this period.

It is best to limit the length of your trips until you break the batteries in and you know the range of your chair.

4.Discharged Batteries:

Never allow a battery to completely discharge. If you operate your wheelchair until it has almost stopped, you will greatly reduce the life of your batteries.

Never let a battery sit in a discharged condition. Give unused or stored batteries a full charge once per month.

Always fully charge the batteries. Avoid “topping off” with frequent charges.

Never connect a life support or auxiliary device to a wheelchair battery.

The electrical system may fail, and result in severe injury to or death of rider.

X I . B a t t e r i e s 45

B. BATTERY CHARGER

A battery charger produces a direct current (DC). When applied to a

discharged battery, this reverses the chemical reaction that led to its discharge.

1.Charge Rate. How fast a battery will charge depends on:

Its electrical capacity; state of charge; electrolyte temperature, and; internal condition.

The DC output of the charger. (The charge rate will vary if the alternating current (AC) supply is higher or lower than 110 volts).

2.Caution — To Avoid Damage to the Charger:

Never place the charger on top of a battery during charging. (Gases from the battery can damage the charger and may lead to an explosion or fire).

Never place a battery on top of the charger.

Never expose charger to rain or snow.

Never unplug charger by pulling on the electrical cord. This will damage the cord.

Never open a charger or attempt to repair it yourself. Return charger to Sunrise or have repairs made only by a qualified person.

Keep cord out of the way, where it will not be stepped on, tripped over, or damaged.

3.Caution — To Avoid Damage to the Battery:

Make sure you use the correct setting for sealed (gel) batteries (located on the off-board charger).

Never charge a frozen battery. A fully charged battery will rarely freeze, but the fluid in a discharged battery can freeze at 16 degrees Fahrenheit (minus 9 degrees Centigrade). If you suspect a battery is frozen, thaw it before charging.

Lead acid batteries generate explosive gas while charging. Completely read and follow all warnings about the batteries in this user instruction manual and any labels applied to the product. Failure to do so could result in fire, explosion, injury and/or death.

930475 Rev. A

930475 Rev. A

Image 23
Contents Quickie P-220 303 218-4500 or 800 N t r o d u c t i o nSunrise Listens Sunrise MedicalEMI T a b l e o f C o n t e n t sDrive Wheels WeightBattery Charger Seat Frame DimensionsReview this Manual Often Choose the Right Chair & Safety OptionsAdjust Chair to Your Ability What is EMI?Report ALL Suspected EMI Incidents Sources of EMIDistance from the Source Immunity LevelG e n e r a l W a r n i n g s Weight LimitController Settings Safety CHECK-LISTEnvironmental Conditions Changes & AdjustmentsWhen Seated in a Parked Wheelchair Motor Vehicle SafetyIf YOU Must Reach or Lean do SO AT Your OWN Risk Center of BalanceTransfers Reaching or LeaningBeware N e r a l W a r n i n g sDriving in Reverse RAMPS, Slopes & SidehillsStairs At a MinimumWheelchair Lifts Curbs & Single StepsR n i n g s C o m p o n e n t s & O p t i o n s Seating Systems Pneumatic TiresPositioning Belts Optional Push HandlesTo Descend a Curb or Single Step S e t U p , a d j u s t m e n t & U s eTo Climb a Curb or Single Step CHECK-OUT Power Drive UnitBattery Removal Tools YOU will NeedFolding Backrest Integral Joystick Installation SWING-AWAY FootrestsRemote Joystick Installation Option To Adjust the Height of the Remote JoystickSeat Depth DUAL-POST HEIGHT-ADJUSTABLE ArmrestsSingle Post HEIGHT-ADJUSTABLE Armrests Optional Joystick SWING-AWAY Retractable Mount OptionalWheel Locks Drive WheelManual Wheelchair Conversion KIT Joystick Dynamic StabilizerInserting Anti-Tip Tubes Into Receiver Installation of Axle Tube AssemblyRear Wheels ANTI-TIP TubesQtronix Programming PAD Optional Performance Control SettingsP e r a t i n g G u i d e Thermal ROLL-BACKRemote Joystick Assembly Optional To slow or stop your chair, return the joystick to neutral Joystick Boot FRemote Switch Jacks optional- not shown Joystick EIntroduction Battery ChargerI . B a t t e r i e s B a t t e r i e sShort Connecting Batteries in Battery CompartmentNever look directly into cells when charging battery Acid Burns Unsealed WET Cell BatteriesStorage Tips CleaningI . M a i n t e n a n c e Disposing of BatteriesTo Repair or Replace a Tire Battery MaintenanceI I . M a i n t e n a n c e I I . W i r i n g D i a g r a m Limitations Remote Joystick Wiring Diagram DetailAdditional Warranty For LifeSunrise Medical