Multiquip HATZ1D81S-325 manual Battery is not included with this machine

MAINTENANCE

BATTERY

NOTICE

Battery is not included with this machine

The standard battery is a maintenance-free battery. It is not necessary to supply battery fluid. In case of a sudden voltage drop, the battery cannot be charged quickly, so it has to be replaced with a new one.

Checking Battery Capacity

1.Check the battery checker on the hour tachometer (Figure 32).

HOUR TACHOMETER	Battery checker
DIESEL ENGINE TACH &HOUR METER

Figure 32. Battery Check

2.When the battery charge gets low, the battery checker lights red.

NOTICE

If an old battery is used, even when the battery checker is not lighted (indicating low charge), the cell starter might not operate because of low charging level. If that happens, change the battery with the new one.

Changing the Battery

1.Unlatch the two stoppers at the top portion of the rear cover to open the rear cover (Figure 33).

Stopper Rear cover

Figure 33. Opening Rear Cover.

2.Loosen the two bolts on each side of the bar connecting the battery to the side rails (Figure 34).

SLIDE BAR UPWARD

TO ACCESS

BATTERY

LOOSEN

BOLT

(4 PLACES)

BATTERY

Figure 34. Raising the Battery

3.Slide the bar up the notches for easy access to the battery and tighten the bolts.

4.Take off the nuts and remove the battery holder (Figure 35).

5.After tilting the battery backward, disconnect the battery terminal. Always disconnect the black terminal on the negative side first.

6.Pull up the handle on the top of the battery to remove the battery from the machine.(Figure 35). Make sure that the battery terminals do not touch the frame.

PAGE 30 — MVH508DZ PLATE COMPACTOR • OPERATION AND PARTS MANUAL — REV. #0 (04/04/14)