Invacare RPS350-2 manual Installation, Introduction, Assembling the Mast to the Base

INSTALLATION

SECTION 2— INSTALLATION

Introduction

WARNING

Use only Invacare parts in the assembly of this lift. The base legs, mast, and boom assembly and the swivel bar are manufactured to specifications that assure correct alignment of all parts for safe functional operation.

Assembling the Mast to the Base

WARNING

The mast may be removed from the base for storage or transporting. Each time the mast is removed and returned to the base, the mast MUST be properly secured to the base assembly.

NOTE: For this procedure, refer to FIGURE 2.1.

1.If locking‐type casters are on the lift, lock them.

2.Remove the shoulder bolt, nut and washer, that secures the mast in the U‐shape cut‐ out of the base.

3.Position the mast in an upright position and place the mast into the U‐shaped cut‐out of the base.

4.Insert shoulder bolt with washers through the base and mast.

5.Secure with nut.

Mast Washer

Shoulder

Nut

Bolt	U-Shaped
	Cut-Out

FIGURE 2.1 Assembling Mast to Base

Stand Up Lift Model RPS350-2 14 Part No. 1145811