INSTALLATION
Assembling the Mast Actuator
CAUTION
DO NOT overtighten the nut and bolt. This damages the mounting bracket.
NOTE: For this procedure, refer to FIGURE 2.2.
1.Remove the top nut, top bolt, bracket, and bushing from the mounting bracket on the mast.
2.Position the mast actuator in the lift arm mounting bracket.
3.Install the top nut, top bolt, bracket, and bushing into the mounting bracket and mast actuator.
4.Tighten securely.
Mounting | Top Nut |
Bracket | Bracket |
| |
| Top Bolt |
Bushing
Mast
Actuator
FIGURE 2.2 Assembling the Mast Actuator
Installing the Leg Actuator to the Base
NOTE: For this procedure, refer to FIGURE 2.3 on page 16.
1.Slide the leg actuator into the slot in the base of the lift. See Detail “B”.
2.Perform the following to secure the leg actuator to the pivot bracket (Detail “A”):
WARNING
Ensure that there is sufficient room to turn lift on its side and that floor area is clear of debris. Otherwise, injury to personnel or damage to lift may occur.
A.Turn the lift on its side.
B.Position slot in leg actuator over the pivot bracket.
C.Install the pin through the leg actuator and pivot bracket and secure with hitch pin.
D.Return the lift to the upright position.
3.Perform the following to secure the leg actuator to the mast bracket (Detail “B”):
A.Position leg actuator between mast bracket.
B.Move the legs to align the holes in the leg actuator with the holes in the mast bracket.
C.Install the pin through the holes of the leg actuator and mast bracket and secure with hitch pin.
4.Plug the pendant control into the bottom of the control box.
Part No. 1145811 | 15 | Stand Up Lift Model |