FOOTRESTS
REMOVAL - Standard
Release winged screw A and slide the complete assembly from the seat frame. Ensure the winged screw is fully tightened when the footrest assembly is replaced.
REMOVAL - Swing - Away
Release the locking lever, swing footrest to the side, or lift up and off. Do this before sitting in the chair.
CAUTION:: ItItisisrecommended thatt both footrests are firmly locked in place when
!platesIf the. Ifweightthe weightof theof bodythe bodyis placedis
the.seatedin the chair(particularlywheny whendrivingdrivingthe thechair)chair). NEVER. NEVERstandstandon
ADJUSTMENT
To extend the ffootrestlaterallly,release the winged screw A, pull the ffootrestt forward,
It is not necessary to rrellease the grub |
| ||
screw B. This should | remaiin |
| |
permanentlly iin position. |
|
| |
To adjust the footrest llengtth,, lloosen |
| ||
the hex nut C on the exttensiion ttube, |
| ||
use a twisting motion when slidiing tthe |
| ||
telescopic tube in and outt.. Be surre to |
| ||
| |||
desired heightt iis achieveded.. |
|
| |
THE LOWEST PART OF THE |
| ||
FOOTREST MUST BE AT LEAST |
| ||
6cm ((2½”)•“) FROM THE GROUND |
| ||
FOR CLEARANCE. . |
|
| |
|
|
| |
| ELEVATING LEGRESTS |
| |
| To raise or lower, release the lock by moving |
| |
| the lever forward as shown. |
| |
| When lowering the legrest, support the |
| |
| weight of user’s leg then release the lock, |
| |
| keep it from dropping | too quickly. Keep in | LOCKING LEVER |
| mind that the lowest part of the footplate must |
| |
| be 6cm (2”) from the ground. |
| |
|
|
|
|
19