Invacare Spectra Plus user manual Armrest Adjustment

Page 7

Armrest Adjustment

The armrest can be pre-set for height by positioning the self-tapping screw (F) in one of the holes in the armrest tube. To adjust the height of each armrest, first release the locking lever (E) which clamps the arm tube, while holding onto the armrest. Move the armrest to the desired height position, re-tighten the locking wing screw (E). The locking lever (if fitted) can be re-positioned without losing the clamping pressure, pull the lever slightly

outwards and turn to a more suitable locating angle.

The padded side panel can also be set to a desired height. Loosen the slotted screw (D) located in the fixing bracket, re-tighten when desired position is achieved.

Width Adjustment

The transverse width adjustment is achieved by releasing locking lever (G) and positioning the armrest tube to width required and re-tightening locking lever (G). To remove the transverse width adjustment armrest assembly complete to allow removal of the front battery box/controller assembly: remove seat, release locking lever (G), depress spring button lock (F) and withdraw complete armrest unit sideways.

NOTE: When re-assembling to chair always ensure the spring button lock (F) is on the inside of the horizontal mounting tube of the sideframe to prevent accidental dismantling of armrest unit.

CAUTION: The armrests are not intended for carrying the wheelchair.

5

Image 7

Contents Spectra Plus Contents Advisory Safety Notice Purpose of the Power ChairForeword Safety Precautions Getting Acquainted with Your NEW Power ChairJoystick FeaturesSeat Depth Adjustment 35mm depth adjustment Seat and Backrest AdjustmentBackrest Angle Adjustment Armrest Adjustment MANUALALTILTT--IN--SPACE TensiontensionadjustableadjustablebackrestPilot Integral Handling and Operation ControllersRecommended Driving Position Dynamic DL ControllerDriving the Wheelchair Important Information for Your Safety IntroductionDX-REMG80IMASTER Remote Handling and TransportationFault Diagnostics MaintenanceSafety and Misuse Warnings Side Lights Controlling Lighting Functions Using the KeypadLeft and Right Indicators Appendix aNegotiating GRADIENTS/SLOPES PILOT+Negotiating Kerbs Controls Joystick Module DetailsHorn Switch Maximum Speed Indicator Speed Adjustment Mode Chin Control Attendant Control Controller OptionsDUAL/ATTENDANT Control Circuit Breakers 30 AMPTransfers For Clearance Elevating Legrests AdjustmentFootrests Lowest Part Footrest Must be AT LeastLevers Pointing Rearwards Pushing the Chair Freewheel ModeGoing Down a Kerb RE-ASSEMBLYOperating the Chair Outdoors Kerb Climbing Going UP a KerbDIS-ASSEMBLY Detachable Motors Drive WHEEL-LOCKS Manual Brakes Drive Wheel RemovalLabelled „TIIEDOWNPOINTPOINT Diiagram Fig. No..2 shows Power chair was ttestted toOccupant’s inertia seat belt Which also must be used Fig. No.3 TransportationOperation Removal Switch OFF the Controller Tray Assembly Fitting Operation InstructionsShown in Fig Lateral Support Fitting InstructionsBatteries Charging BatteriesMains Socket Charger Controller Front Pollution from improper disposal Battery ConnectionsCHROME/PAINTWORK Keeping Your Chair in Good ConditionFault Finding Technical Information Spectra PlusDaily Weekly Monthly Yearly Approved Accessories Available Models Covered Spectra Plus Spectra Plus