Invacare Spectra Plus user manual Dis-Assembly

Page 24

DIS-ASSEMBLY

To enable the chair to be carried in the boot of most cars, follow these instructions:

Step 1: Disconnect the Motor/Battery connector from the control box and remove the armrests. Release the locking lever.

Step 2: Remove the calf strap from the footrests. This is simply attached by Velcro fastening. Remove the footrests completely by releasing the cam latch situated on the inside of the footrest frame hanger. CAUTION: Do not drive the chair with the footrests in the unlatched position.

Step 3: Remove the kerb climber assembly (if fitted) as described.

Step 4: Detach the seat and backrest assembly as previously shown. When replacing the seat assembly, ensure the brackets are located correctly on the seat frame tube.

Step 5: Disconnect the motor leads and the connecting cables from the battery boxes. Carefully lift the battery boxes clear of the frame by the straps provided. Remove the battery tray. When refitting the battery tray it is important that it is correctly located on the support pins.

Step 6: Remove the detachable motors as described.

The disassembled chair is now ready to be loaded safely in a suitable vehicle. Reversing the procedure will allow the chair to be reassembled at your destination.

SPECIAL NOTE: Care must be taken when stowing the detached parts for transportation to ensure that no damage occurs, particularly to the motor assemblies and controller units.

Due to the weight of the battery boxes, consideration must be given to their secure positioning in the event of emergency braking.

EXTREME CARE MUST BE TAKEN WHEN LIFTING THE HEAVIEST COMPONENTS I.E. BATTERY BOXES, FRAME AND MOTOR UNITS. ASSUME THE CORRECT LIFTING POSITION. SEEK ASSISTANCE IF IN DOUBT.

22

Page 23 Page 25
Image 24
Page 23 Page 25
Contents Spectra Plus Contents Purpose of the Power Chair Advisory Safety NoticeForeword Getting Acquainted with Your NEW Power Chair Safety PrecautionsFeatures JoystickSeat and Backrest Adjustment Seat Depth Adjustment 35mm depth adjustmentBackrest Angle Adjustment Armrest Adjustment Tensiontensionadjustableadjustablebackrest MANUALALTILTT--IN--SPACEHandling and Operation Controllers Pilot IntegralDynamic DL Controller Recommended Driving PositionImportant Information for Your Safety Introduction DX-REMG80IMASTER RemoteHandling and Transportation Driving the WheelchairMaintenance Fault DiagnosticsSafety and Misuse Warnings Controlling Lighting Functions Using the Keypad Left and Right IndicatorsAppendix a Side LightsPILOT+ Negotiating GRADIENTS/SLOPESNegotiating Kerbs Joystick Module Details ControlsHorn Switch Maximum Speed Indicator Speed Adjustment Mode Controller Options DUAL/ATTENDANT ControlCircuit Breakers 30 AMP Chin Control Attendant ControlTransfers Adjustment FootrestsLowest Part Footrest Must be AT Least For Clearance Elevating LegrestsPushing the Chair Freewheel Mode Levers Pointing RearwardsRE-ASSEMBLY Operating the Chair Outdoors Kerb ClimbingGoing UP a Kerb Going Down a KerbDIS-ASSEMBLY Detachable Motors Drive Wheel Removal Drive WHEEL-LOCKS Manual BrakesPower chair was ttestted to Labelled „TIIEDOWNPOINTPOINT Diiagram Fig. No..2 showsOccupant’s inertia seat belt Which also must be used Transportation Fig. No.3Tray Assembly Fitting Operation Instructions Operation Removal Switch OFF the ControllerLateral Support Fitting Instructions Shown in FigCharging Batteries BatteriesMains Socket Charger Controller Front Battery Connections Pollution from improper disposalKeeping Your Chair in Good Condition CHROME/PAINTWORKFault Finding Spectra Plus Technical InformationDaily Weekly Monthly Yearly Approved Accessories Available Models Covered Spectra Plus Spectra Plus
Top Page Image Contents