SECTION 6—FRONT RIGGINGS
Removing
1.Push the footrest release lever inward.
2.Rotate swingaway footrest assembly outward.
3.Lift the swingaway footrest assembly off of the hinge pins.
Using
1.To move the footrest out of the way without removing, push the footrest release lever inward, rotate footrest outward.
2.To lock the footrest, push the swingaway footrest assembly towards the inside of the wheelchair until it locks into place.
NOTE: The footplate will be on the inside of the wheelchair when locked in place.
Adjusting the Footrest Height
NOTE: For this procedure, refer to FIGURE 6.2.
NOTE: This procedure applies to the swingaway footrest and elevating legrest.
1.Remove the swingaway footrest assembly. Refer to Installing/Removing/Using the Footrest/Legrest on page 33.
NOTE: Lay the assembly on a flat surface to simplify this procedure.
2.Remove impact guards and/or calf strap, if installed.
3.Pull the cam lock lever up to the unlocked position.
4.Push in the release buttons and reposition the lower footrest assembly to the desired height.
5.Ensure that the release buttons fully protrude from holes on both sides of the upper footrest support.
6.Rotate cam lock lever down to locked position.
7.Replace impact guards and/or calf strap.
8.Repeat this procedure for the other footrest, if necessary.
9.Reinstall the swingaway footrest assembly. Refer to Installing/Removing/Using the Footrest/Legrest on page 33.
Upper Footrest Support
Release Button
Adjustment 
Holes
| Lower Footrest |
Cam Lock Lever | Assembly |
FIGURE 6.2 Adjusting the Footrest Height
34 | Part No. 1123839 |