Invacare XP6520, XP6500 manual Replacing Battery Box Retaining Strap

SECTION 11—BATTERIES

Detail “A” - Dual UI Batteries

1/4-20 x 7/8-Inch	NEGATIVE (-)		NEGATIVE (-)
Hex Flange Screw	Terminal/Post
		POSITIVE (+)	Terminal/Post	GREY
POSITIVE (+)		Terminal/Post		Terminal
	1/4-20			Cap
Terminal/Post
	Hex
	Flange
	Locknut
Connect Cable
Ring Terminal
to This Side of
Terminal/Post		ORANGE
			Tie-Wraps
		Terminal Cap

Detail “B” - Installing Battery Terminal Cap onto Battery Cable

NOTE: For clarity, only one cable
and terminal cap are shown. Both
caps install in the same manner.	Cable
Terminal Cap
FIGURE 11.7 Connecting Battery Cables

Replacing Battery Box Retaining Strap

WARNING

The battery box retaining strap MUST be fastened securely and adjusted properly to hold battery boxes in place before using the wheelchair.

NOTE: For this procedure, refer to FIGURE 11.8 on page 55.

1.Remove the battery boxes from the wheelchair. Refer to Removing/Installing the Battery Boxes on page 49.

2.Remove the battery tray from the wheelchair. Refer to Installing/Removing Battery Tray on page 50.

WARNING

The retaining strap MUST be fed through the adjustable end of the battery box retaining strap buckle as shown in FIGURE 11.8.

NOTE: Take note of the position and orientation of the battery box retaining strap as it passes through the slots of the battery tray and the adjustable end of the battery box retraining strap buckle.

54 Part No. 1123839