Invacare XP6520, XP6500 manual Grounding Instructions, Rain Test

Page 14

SECTION 1—GENERAL GUIDELINES

Grounding Instructions

DANGER

When using an extension cord having at least 16 AWG (American Wire Gauge) wire and the same or higher electrical rating as the device being connected. Use of improper extension cord could result in a risk of fire and electric shock. Three prong adapters can result in improper grounding and present a shock hazard to the user.

DO NOT, under any circumstances, cut or remove the round grounding prong from any plug used with or for ProBasics products. Some devices are equipped with three-prong (grounding) plugs for protection against possible shock hazards and fire. Where a two-prong wall receptacle is encountered, it is the personal responsibility and obligation of the customer to contact a qualified electrician and have the two-prong receptacle replaced with a properly grounded three-prong wall receptacle in accordance with the National Electrical Code. If you must use an extension cord, use ONLY a three-wire extension cord having the same or higher electrical rating as the device being connected. In addition, ProBasics has placed RED/ORANGE warning tags on some equipment. DO NOT remove these tags.

Rain Test

ProBasics has tested its power wheelchairs in accordance with ISO 7176 “Rain Test.” This provides the end user or his/her assistant sufficient time to remove his/her power wheelchair from a rain storm and retain wheelchair operation.

DO NOT leave power wheelchair in a rain storm of any kind.

DO NOT use power wheelchair in a shower or leave it in a damp bathroom while taking a shower.

DO NOT store power wheelchair in a damp area for an extended period of time.

Direct exposure to excessive rain or dampness may cause the chair to malfunction electrically and mechanically, may cause the chair to prematurely rust or may damage the upholstery.

Check to ensure that the RED and GREY battery terminal caps are secured in place, joystick boot is NOT torn or cracked where water can enter and that all electrical connections are secure at all times.

DO NOT use the wheelchair if the joystick boot is torn or cracked. If the joystick boot becomes torn or cracked, replace IMMEDIATELY.

14

Part No. 1123839

Image 14
Contents XP6500 XP6520 Page Table of Contents Arms Wheelchair OperationFront Riggings Seat and BackCLUTCH/MOTOR Lock Limited WarrantyBatteries Wheel LocksSpecial Notes Signal Word MeaningSpecial Notes Wheelchair TIE-DOWN Restraints and Seat RestraintsSpecial Notes Typical Product Parameters XP6500 XP6520Label Locations Important NoticeOperating Information Controller Settings/Repair or ServiceGeneral Guidelines General Guidelines Batteries Electrical AccessoriesTire Pressure Charging Batteries Grounding Instructions Rain TestWeight Training Weight LimitationEMI Information EMI InformationEMI Information Coping With Everyday Obstacles SAFETY/HANDLING of WheelchairsStability and Balance Tipping Tipping CurbsLifting/Stairways Transferring to and From Other Seats Escalators WarningPercentage of Weight Distribution Reaching, Leaning and Bending ForwardReaching and Bending Backward Reaching, Leaning and Bending ForwardInspect/Adjust Initially Safety INSPECTION/TROUBLESHOOTINGSafety Inspection Checklists Inspect/Adjust Periodically Inspect/Adjust WeeklyInspect/Adjust Monthly Symptom Probable Cause Solutions Troubleshooting MechanicalTroubleshooting Guide Checking Battery Charge Level DON’TJoystick Switches and Indicators Wheelchair OperationJoystick Switches and Indicators Information Gauge DisplayWheelchair Operation Display Description Definition Comments Using the Joystick to Drive the Chair Turning the Power On/OffUsing the Horn Operating the WheelchairMovement Action ReverseFront Riggings Installing/Removing/Using the Footrest/LegrestInstalling Removing Adjusting the Footrest HeightUsing Raising/Lowering the Legrest Assembly Replacing the Heel LoopRaising/Lowering the Legrest Assembly Adjusting Armrest Height ArmsSwing-Back Arms Replacing Armrest PadSeat Depth Number of Screws Seat and BackReplacing the Seat Upholstery Replacing the Back Upholstery Replacing the Back UpholsteryAdjusting the Back Height Adjusting the Back HeightReplacing Seat Positioning Strap Replacing Seat Positioning StrapJoystick Preparing the Joystick for UseRepositioning the Joystick Repositioning the JoystickAdjusting Forks CastersWhen to Charge Batteries BatteriesTools Quantity Comments Description and Use of Battery ChargersCharging Batteries QTY Volts Battery Remarks Width Connecting the Battery ChargerRecommended Battery Types Replacing the BatteriesImmediately Removing/Installing the Battery BoxesCleaning Battery Terminals Installing/Removing Battery Tray Removing/Installing Battery BoxesInstalling/Removing Batteries Into/From Battery Boxes Tool QTY CommentsConnecting Battery Cables Installing/Removing Batteries Into/From Battery BoxesBatteries Replacing Battery Box Retaining Strap Replacing Battery Box Retaining Strap CLUTCH/MOTOR Lock Engaging/Disengaging the ClutchesWheel Locks Installing/Adjusting/Using the Wheel LocksInstalling/Adjusting Installing/Adjusting/Using the Wheel Locks ANTI-TIPPERS Installing/Removing/Adjusting Anti-TippersAdjusting Height Installing/Removing/Adjusting Anti-Tippers Unfolding/Folding the Wheelchair TransportingTransporting the Wheelchair Transporting the Wheelchair Limited Warranty Probasics