Insignia
Cleaning CDs
A dirty disc causes sound skipping, and if the disc is very dirty, the CD may not work at all. Handle the disc by holding its inner and outer edges.
•Fingerprints and dust should be carefully wiped from the surface of the CD with a soft cloth. Wipe in a straight motion from the center to the edge.
•Never use thinner, benzine, record cleaner, or
Specifications
Design and specifications are subject to change without notice.
Power sources |
|
|
|
Power supply | 120 V AC |
| 60 Hz |
|
|
Remote control | 3 V (1) |
batteries |
|
Power | 15 W |
consumption |
|
Note
Before transporting the unit, remove any disc from the disc compartment.
Troubleshooting
Problem | Solution | |
|
| |
No sound. | • Turn the volume knob up. | |
| • The headphones are connected. | |
|
| Disconnect them. |
| • Reset the unit by pressing the ON/OFF | |
|
| button. |
|
| |
No or | Check the speaker connections of the | |
unbalanced | inoperative speaker. | |
sound from a |
|
|
speaker. |
|
|
|
| |
Reversed left | Check the speaker cord connection and | |
and right | speaker location. | |
sound. |
|
|
|
| |
Severe hum or | • A TV or VCR is too close to the shelf | |
noise. |
| system. Separate the shelf system |
|
| from the TV or VCR. |
| • The plugs and jacks are dirty. Wipe | |
|
| them with a cloth slightly moistened |
|
| with alcohol. |
| • | Clean the disc. |
| • Adjust the antenna wire. | |
|
| |
The FM stereo | Reception is poor. Adjust the antenna wire. | |
indicator |
|
|
flashes. |
|
|
|
| |
CD door does | • Press the ON/OFF button to turn on | |
not close due to |
| the shelf system. |
power off or | • Press the Function button to select CD | |
other functions |
| mode. |
are selected | • Press the Open/Close button to close | |
without first |
| the CD door. |
closing the |
|
|
door |
|
|
|
| |
The disc does | • The disc is not inserted correctly or is | |
not play |
| upside down. Insert the disc correctly. |
| • | Clean the disc. |
| • The CD system is in the pause mode. | |
|
| Press the Play button to leave pause |
|
| mode. |
|
| |
Distorted | • Condensation may have formed inside | |
playback or |
| the unit because of a sudden change |
sound loss |
| in temperature. Wait about an hour for |
during CD |
| the condensation to evaporate and try |
playback |
| again. |
| • CD disc is dirty or scratched. Clean | |
|
| the disc. |
|
|
|
FCC compliance
This equipment has been tested and found to comply within the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•Consult the dealer or an experienced technician for help.
Safety certification
This shelf system is made and tested to meet safety standards of the FCC, requirements and compliance with safety performance of the U.S. Department of Health and Human Services, and also with FDA Radiation Performance Standards 21 CFR Subchapter J.
Warranty information
Limited warranty
Insignia Products warrants to you, the original purchaser of this Product, that this product shall be free of defects in material or workmanship for a period of ninety (90) days from the date of purchase as follows:
1LABOR: During the Warranty Period if this Product is determined to be defective, Insignia will repair or replace the Product, at its option at no charge, or pay the labor charges to any Insignia authorized service facility. After the Warranty Period, you must pay for all labor charges.
12 | ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
