Insignia NS-A1111 manual Setting up your shelf system, Preparing the remote control, Display

NS-A1111_final_translationDTP.fm Page 6 Friday, February 17, 2006 12:09 PM

Insignia NS-A1111 5-CD Shelf System

Control	Symbol	Description
Tuning (down) button		Press to adjust radio setting
		from a higher to lower
		frequency.
TIMER button		Press to set a timer alarm.
Volume +/- buttons		Press to adjust the volume.
Disc skip button		Press to skip playing an
		entire disc loaded in the CD
		changer.
Tuning (up) button		Press to adjust radio setting
		from a lower to higher
		frequency.
Play/pause button		Press to start or resume
		playing a disc.
		Press to pause playback of
		disc.
Skip forward/preset+		Press to start, pause, or
button		resume playing a disc.
Repeat button		Press to replay a track.
Band button		Press to switch between AM
		and FM radio bands
Function button		Press to switch between CD,
		tuner, and aux in.

Setting up your shelf system

Preparing the remote control

Installing remote control batteries

I

Warning

Do not throw the batteries into fire. Dispose of used batteries as hazardous waste.

I

Caution

Do not drop or disassemble the remote control. Do not get the remote control wet.

To install batteries in the remote control:

1Remove the battery cover.

2Insert one CR2025 (3-volt) battery into the battery compartment. Make sure that the +/– symbols on the battery match the +/– marks inside the battery compartment.

Display

Band		STEREO
		MEMORY
Clock		Repeat
AM/PM
		mode
		Radio
Clock/CD		frequency
track/
broadcast
station
Indicator	Description
Band	Displays FM or AM radio band.
Clock AM/PM	Indicates that the time is AM or PM.
Clock/CD track/	• In clock mode, displays the time.
broadcast station	• In CD mode, displays the track
	number.
	• In broadcast station mode,
	displays the station number.
MEMORY	Displays when the track being played is
	stored in memory.
STEREO	Indicates that the FM signal is playing in
	stereo.
REPEAT mode	Displays when the repeat feature is in
	use.
Radio frequency	Shows whether the radio frequency is
	megahertz or kilohertz.

3Replace the battery cover.

4Remove the plastic tab covering the remote control sensor.

5Point the remote control at the remote sensor on the shelf system. The effective distance for remote operation is about 16 feet (5 meters).

Note

When using the remote control and you are required to move closer to the stereo for the remote control to operate, replace the battery. The remote control may not operate correctly if direct sunlight or the light of a high-frequency fluorescent lamp enters the remote control light sensor. In this case, change the system installation position to prevent the problem.

Note

When the remote control will not be used for a long period of time or when the batteries are worn out, remove the batteries to prevent leakage.

6 www.insignia-products.com