Invacare R51LXP, R50LX manual Front Riggings, Installing/Removing the Footrests

SECTION 6—FRONT RIGGINGS

SECTION 6—FRONT RIGGINGS

WARNING

After ANY adjustments, repair or service and BEFORE use, make sure that all attaching hardware is tightened securely - otherwise injury or damage may result.

Installing/Removing the Footrests

NOTE: For this procedure, refer to FIGURE 6.1.

Installing

1.Turn footrest to the side (open footplate is perpendicular to wheelchair) and position mounting holes in the footrest hinge plates with hinge pins on the wheelchair frame.

2.Install the footrest hinge plates onto the hinge pins on the wheelchair frame.

3.Push the footrest towards the inside of the wheelchair until it locks into place.

NOTE: The footplate will be on the inside of the wheelchair when locked in place. 4. Repeat STEPS 1‐3 for the opposite side of the wheelchair.

Removing

1.Push the footrest release lever inward and rotate the footrest outward.

2.Lift up on footrest and remove from the wheelchair.

3.Repeat STEPS 1‐2 for the opposite side of the wheelchair.

Footrest Release Lever

Hinge Pins

Footrest Hinge Plate

FIGURE 6.1 Installing/Removing the Footrests

Nutron® Series 31 Part No.1106645