SECTION
Adjusting Calfpads
1.Turn calfpad towards the outside of the wheelchair.
2.Slide calfpad up or down until desired position is obtained.
NOTE: If one (1) of the top two (2) calfpad adjustment positions is being used, the legrest will need to be raised to avoid interference with the front stabilizers while going over obstacles or going up and down ramps. Refer to Raising/Lowering Elevating Legrests on page 34.
3. Turn the calfpad toward the inside of the wheelchair.
Calfpad Rotated for Height
Release Lever
Adjustment
Calfpad
Top Two (2) Calfpad
Adjustment Positions
FIGURE 6.6 Raising/Lowering Elevating Legrests and/or Adjusting Calfpads
Adjusting/Replacing Telescoping Front Rigging Support
NOTE: For this procedure, refer to FIGURE 6.7.
NOTE: When adjusting the telescoping front rigging support depth, ensure the footplate does not interfere with the caster wheel rotation.
1.Lift up on the crossbraces until they release from the H‐blocks on the wheelchair frame.
2.Remove the long socket bolt and locknut that secure the front H‐block and spacer to the wheelchair frame and telescoping front rigging support.
3.Remove the front, and rear short socket bolts and the two (2) locknuts that secure telescoping front rigging support to wheelchair.
Nutron® Series | 35 | Part No.1106645 |