Invacare R50LX, R51LXP manual Replacing Heel Loops, Model 93M, 904A, PAL4A, and PAS4A Footrests

SECTION 6—FRONT RIGGINGS

Model 93M, 904A, PAL4A, and PAS4A Footrests

NOTE: For this procedure, refer to FIGURE 6.3.

1.Loosen, but do not remove the lug bolt and locknut that secure the lower footrest to the footrest support.

2.Reposition the lower footrest to the desired height.

3.Securely tighten the lug bolt and locknut that secure the lower footrest to the footrest support.

4.Repeat STEPS 1‐3 for the other footrest, if necessary.

Lug Bolt

Footrest Support

Locknut Lower Footrest

NOTE: 93M style footrest shown. 904A, PAL4A and PAS4A footrests adjust the same way.

FIGURE 6.3 Adjusting the Footrest Height - Model 93M, 904A, PAL4A, and PAS4A Footrests

Replacing Heel Loops

NOTE: For this procedure, refer to FIGURE 6.4.

1.Note the position of hex bolt, coved washers and locknut for reinstallation.

2.Remove the hex bolt, coved washers and locknut that secure the lower footrest to the footrest support.

3.Remove the lower footrest.

4.Remove the phillips bolt, spacer and locknut that secure the existing heel loop to the lower footrest.

5.Slide the existing heel loop off the lower footrest.

6.Replace heel loop.

7.Reverse STEPS 1‐6 to reassemble.

	Footrest Support
Locknut	Hex Bolt
	Phillips Bolt
Coved
Washers
	Spacer
Lower Footrest	Heel Loop

Locknut

FIGURE 6.4 Replacing Heel Loops

NOTE: When securing heel loop to lower footrest, tighten the phillips screw and locknut until the spacer is secure.

Nutron® Series 33 Part No.1106645