Invacare R51LXP, R50LX manual Replacing Seat Positioning Strap, Replacing Back Upholstery

SECTION 9—UPHOLSTERY/SEAT POSITIONING STRAP

4.Pull the loose back canes out of the existing back upholstery.

5.Slide the loose back canes into the new back upholstery.

6.Secure the back canes to the wheelchair frame with the mounting screws and locknuts removed in STEP 1.

7.Secure the new back upholstery to the back canes with the two (2) existing upholstery mounting screws and washers.

Washer	NOTE: All four (4) mounting
	screws and locknuts are shown.
	Each fold‐down back cane uses
	two (2) mounting screws.
Upholstery	Back Cane

Mounting		Mounting Screws
Screws
Back Upholstery	Locknuts
		Wheelchair Frame
FIGURE 9.2 Replacing Back Upholstery

Replacing Seat Positioning Strap

NOTE: For this procedure, refer to FIGURE 9.3.

1.If necessary, remove the seat cushion from the seat upholstery.

2.Remove the two (2) rear phillips screws and washers that secure the seat upholstery and seat positioning strap to the crossbraces.

3.Remove the two (2) halves of the seat positioning strap from the crossbraces.

4.Position the two (2) new seat positioning strap halves between the seat upholstery and the crossbraces.

5.Reinstall the rear phillips screws and washers that secure the seat upholstery and seat positioning strap to the crossbraces.

NOTE: Washer is positioned on top of seat upholstery.

6. If necessary, reinstall the seat cushion onto the seat upholstery.

Part No.1106645 44 Nutron® Series