Invacare OCMK01, OCMK78 Adjusting the Contour U Seating System Seat Angle Figure

Page 15
DETAIL "A"

ADJUSTING THE CONTOUR U SEATING SYSTEM SEAT ANGLE (FIGURE 12)

NOTE: Before performing this procedure all four (4) J brackets must be adjusted to the same height. Refer to ADJUSTING THE CONTOUR U SEAT HEIGHT in this instruction sheet.

NOTE: The seat angle is adjusted by repositioning the front and/or the rear J brackets.

NOTE: Adjustments made to J bracket(s) on one side of the ContourU seat MUST be also be made to the remaining J bracket(s) on the opposite side of the ContourU seat.

1.If necessary, install the ContourU seat. Refer to REMOVING/INSTALLING THE CON- TOUR U SEATING SYSTEM SEAT in this instruction sheet.

2.With the ContourU seat installed on the wheelchair, determine which J bracket mounting positions are necessary to achieve the desired seat angle adjustment.

3.Remove the ContourU seat. Refer to REMOVING/INSTALLING THE CONTOUR U SEATING SYSTEM SEAT in this instruction sheet.

4.Remove the two (2) mounting screws and locknuts that secure the J bracket to the L bracket as shown in DETAIL “A” of FIGURE 12.

5.Align two (2) mounting holes of the J bracket with two (2) mounting holes of the L bracket to acquire the desired depth.

6.Reinstall the two (2) mounting screws and locknuts that secure the J bracket to the L bracket. Securely tighten.

7.Repeat STEPS 4-6 to adjust the remaining J and L brackets as necessary to achieve the desired seat angle.

8.Reinstall the ContourU back onto the wheelchair. Refer to REMOVING/INSTALLING THE CONTOUR U SEATING SYSTEM SEAT in this instruction sheet.

9.Ensure the ContourU seat is set to the desired angle and does not interferer with wheel- chair operation or accessories. If necessary repeat STEPS 1-7 until desired depth is

achieved.

ContourU Seat

J Bracket

Locknuts

Rear J Brackets

Front J Brackets

 

L Bracket

Mounting

 

Screws

Mounting Holes

FIGURE 12 - ADJUSTING THE CONTOUR U SEATING SYSTEM SEAT

ANGLE

15

Image 15
Contents Safety Summary Important Information Installation InformationWheelchair Detail aDetail B FrontInstalling the Back L Brackets Figure PAN BackWood Back Installing the Back J Brackets Installing the Back J Brackets FigureDetail a Detail B INSTALLING/REMOVING the Contour U BackDepth Adjustments Adjusting the Contour U Back Depth FigureAdjusting the Contour U Seating System Back Angle Adjusting the Contour U Seating System Back Angle FigurePage Rear Front WheelchairInstalling the Seat L Brackets Installing the Seat L Brackets FigureInstalling the Seat J Brackets Installing the Seat J Brackets FigureINSTALLING/REMOVING the Contour U Seating System Seat Figure Adjusting the Contour U Seating System Seat Height Adjusting the Contour U Seat Height FigureAdjusting the Contour U Seating System Seat Angle Adjusting the Contour U Seating System Seat Angle FigureCanada One Invacare Way