INSTALLATION OF ON CHAIR MOUNTING KIT SEAT MOUNTING HARDWARE (FIGURE 7)
NOTE: Refer to GENERAL and INSTALLATION WARNINGS in the SAFETY SUMMARY in this instruction sheet.
NOTE: The wheelchair hardware consists of two (2) fixed release clamps and two (2) twist release clamps. The wheelchair hardware must be mounted facing up (on top of the seat rails) with the twist release clamps at the front and the fixed release at the rear of the seat rails.
NOTE: The seat mounting brackets should be placed on the seat rail without interfering with other wheelchair accessories.
1.Install the L brackets onto the ContourU seat. Refer to INSTALLING THE SEAT L BRACKETS in this instruction sheet.
2.Install the J brackets onto the L brackets. Refer to INSTALLING/ADJUSTING THE SEAT J BRACKETS in this instruction sheet.
3.Position the ContourU seat onto the seat rails in the desired location.
4.On the seat rails, mark the front edge of the two (2) front J brackets and the rear edge of the two (2) rear J brackets as shown in DETAIL "A" of FIGURE 7.
5.Remove the mounting screw, washer, lock washer, and internal threaded mounting screw from one of the fixed release clamps.
6.Install the fixed release clamp onto the seat rail so that the open end of the fixed release clamp is facing the front of the wheelchair and aligned with the mark made in STEP 4 as shown in DETAIL "B" of FIGURE 7.
7.Using the mounting screw, washer, lock washer, and internal threaded mounting screw, secure the fised release clamp to the seat rail. Securely tighten.
8.Repeat STEPS
9.Remove the mounting screw, washer, lock washer, and internal threaded mounting screw from one of the twist release clamps.
10.Install the twist release clamp onto the seat rail so that open end of the twist release clamp is facing the rear of the wheelchair and is aligned with the mark made in STEP 4 as shown in DETAIL "B" of FIGURE 7.
11.Using the mounting screw, washer, lock washer, and internal threaded mounting screw, secure the twist release clamp to the back cane. Securely tighten.
12.Repeat STEPS
13.Install the ContourU seat on to the wheelchair. Refer to INSTALLING/REMOVING THE CONTOUR U SEATING SYSTEM SEAT in this instruction sheet.
14.If seat depth and or angle adjustments are necessary refer to ADJUSTING THE CONTOUR U SEATING SYSTEM SEAT in this instruction sheet.
9