Invacare At'm manual Resetting the Circuit Breaker, Multi Function Charger Port

SECTION 5—WHEELCHAIR OPERATION

MULTI FUNCTION CHARGER PORT

WARNING FRONT VIEW OF JOYSTICK

Set-up/programming of the Electronic Control Unit is to be performed only by a qualified technician. The final adjust- ments of the controller may affect other activities of the wheelchair. Damage to the equipment could occur under these circumstances. If unqualified individuals perform any work on these units, the warranty is void.

Multi-Function

Charger Port

FIGURE 5.2 - MULTI FUNCTION

CHARGER PORT

The multi function charger port is located at the front of the joystick housing. This provides easy access for charging the wheelchair batteries. This port also serves as the Remote Programmer Communication connection.

RESETTING THE CIRCUIT BREAKER

WARNING

NEVER defeat or bypass the circuit breaker. ONLY replace with a circuit breaker of the same rating.

NOTE: For this procedure, refer to FIGURE 5.3.

1.Remove the battery pack from the wheelchair base. Refer to Removing/Installing the Battery Pack on page 35.

2.Open the battery pack by performing the following -

A. Grasp the side flaps and pull up.	Protector Ring
B. Grasp the front flap and pull up.
3. To reset - press the circuit breaker reset	Side Flap
button located inside the protector ring
	Front Flap
on top of circuit breaker.

4. Close the battery pack by performing the following -

A.Fold down the front flap and press to engage the hook and loop straps.

B.Fold down the side flaps and press to engage the hook and loop straps.

Circuit Breaker

Reset Button

NOTE: Ensure that the hook and loop straps are securely fastened before lifting the battery pack.

Side Flap

FIGURE 5.3 - RESETTING THE

CIRCUIT BREAKER

At’m 28 Part No. 1125035