Invacare At'm manual REMOVING/INSTALLING the Seat, Removing, Installing

Page 29

SECTION 6—SEAT

SECTION 6—SEAT

WARNING

After ANY adjustments, repair or service and BEFORE use, make sure that all attaching hardware is tightened securely - otherwise injury or damage may result.

Before performing any maintenance, adjustment or service verify that On/Off switch on the joystick is in the Off position.

REMOVING/INSTALLING THE SEAT

NOTE: For this procedure, refer to FIGURE 6.1.

REMOVING

1.Disconnect the joystick. Refer to Disconnecting/Connecting the Joystick on page 32.

2.Remove the battery pack. Refer to Removing/Installing the Battery Pack on page 35.

3.Pull up the front seat release loop and tilt the seat back. Refer to Detail “A” of FIGURE 6.1.

4.Pull up the rear seat release cord with the other hand and lift the seat assembly off and away from the wheelchair base. Refer to Detail “B” of FIGURE 6.1.

5.Fold the seat assembly. Refer to Detail “C” of FIGURE 6.1.

INSTALLING

1. Lower the rear latches onto the rear crossbrace.

NOTE: An audible click is heard as the rear latches lock into place.

NOTE: Ensure both latches sit flush against the rear crossbrace. If not flush, lift the rear seat release cord, remove the seat and repeat STEP 1.

2.Tilt back seat assembly.

3.Unfold the seat assembly.

4.Lower the front latch onto the front cross brace until it locks in place.

NOTE: An audible click is heard as the front latch locks into place.

5.Lift the seat assembly to ensure that the seat is secured to the wheelchair base.

6.Reinstall the battery pack. Refer to Removing/Installing the Battery Pack on page 35.

7.Reconnect the joystick. Refer to Disconnecting/Connecting the Joystick on page 32.

Part No. 1125035

29

At’m

Page 28 Page 30
Image 29
Page 28 Page 30
Contents At’m At’m Table of Contents Seat Table of Contents Complete and mail the form on the next Register Your ProductProduct Registration Form Fold here Cut Along Line Wheelchair TIE-DOWN Restraints and Seat Restraints Special NotesLabel Location Parameters Typical Product ParametersGeneral Guidelines Controller SETTINGS/REPAIR or ServiceTire Pressure Operation InformationGeneral Guidelines Charging Batteries AccessoriesBatteries Weight Limitation Weight TrainingGrounding Instructions Rain TestEMI Information EMI Information Coping with Everyday Obstacles SAFETY/HANDLING of WheelchairsStability and Balance LIFTING/STAIRWAYS Reaching and Bending Backward Percentage of Weight DistributionREACHING, Leaning and Bending Forward INSPECT/ADJUST Initially Safety INSPECTION/ TroubleshootingSafety Inspection Checklists INSPECT/ADJUST Periodically INSPECT/ADJUST WeeklyINSPECT/ADJUST Monthly Symptom Probable Cause Solutions Troubleshooting GuideUsing the Joystick to Drive the Chair Turning the Power ON/OFFWheelchair Operation Operating the WheelchairMovement Action Using the HornON/OFF Button Joystick Switches and IndicatorsSpeed Control Knob JoystickWheelchair Operation Display Description Definition Comments Multi Function Charger Port Resetting the Circuit BreakerInstalling REMOVING/INSTALLING the SeatSeat RemovingREMOVING/INSTALLING the Seat Replacing Seat Positioning Strap Replacing Seat Positioning StrapDisconnecting DISCONNECTING/CONNECTING the JoystickConnecting JoystickRepositioning the Joystick Repositioning the JoystickBatteries Recommended Battery TypeREMOVING/INSTALLING the Battery Pack REMOVING/INSTALLING the Battery PackRemoving Charging Batteries REMOVING/INSTALLING the Batteries FROM/INTO Battery PackMulti-Function Charger Port ENGAGING/DISENGAGING the Motors MotorsReplacing Front Casters Wheels and CastersAdjusting Forks Adjusting ForksREMOVING/INSTALLING the Drive Wheels REMOVING/INSTALLING the Drive WheelsTransporting the Wheelchair USA Limited Warranty
Top Page Image Contents